Owner's Manual

Settings and Parameters
HD Size16:9 Output
Use the V-440HD’s component output for shows and other situations where the video is being output to plasma displays or highdefinition
projectors.
HD Video Output Device
RGB Video Output Device
SD Video Output Device
HD Camera
PC or Other Device
DV Camera, Player, Etc.
Composite
Cable
D-Sub
Cable
Component
Cable
Component
Cable
Final Output (HD)
Plasma Display or Other Display
V-440HD Settings Parameters
Set the following parameters from the menu. Make parameter settings suited for the particular usage environment.
Settings Parameter
1. HD/RGB Output 1. Output Format |1080i| sw,
etc.
* For more on the menus, refer to Menu Operations (p. 25).
Selects optimal format, e.g., 1080i or 720p,
for the connected device.
5. Zooming Set value to 100 when entire screen is not
being displayed.
2. HD/RGB Input 3. Pre Scaling Mode There are times when the RGB video is not
4. Manual Pre Scaling
displayed on the entire screen. Set the “3.
Pre Scaling Mode” to Manual and adjust
with the “4. Manual Pre Scaling” parameter.
5. Scaling Type
(Channel input to RGB and
Channel A/B only)
As the aspect ratio of the video in the RGB
and SD sections (Channel A/B) is not 16:9,
set this to “Fixed Aspect: Letter” or “Fixed
Aspect: Crop.”
3. System 1. System Frame Rate Select the format appropriate for the output
device you are using.
Related Page
p. 26
p. 48
p. 27
p. 49
p. 26
Settings Parameters for Devices Other Than V-440HD
It may be necessary to set the following parameters for connected plasma displays or high-definition projectors.
Settings Parameter
Output Device (e.g., plasma display, high-definition
projector)
Values
Set the input to “Component Input.”
68