HY US 01 Introduction.qxp - Hydrotech

Product Water Resistivity vs Gallons Through-put
Test Conditions
RO FEED WATER ............15 - 20 TDS
pH ......................................6.5 - 7.5
CITY FEED WATER ..........170 TDS
TEMPERATURE ................77 +/- 2°F
Cartridges
Flow Rate
(1) PCF-1-10MB ................0.25 GPM
(2) PCF1-20MB..................0.50 GPM
(3) BBF1-20MB..................1.25 GPM
(4) Two PCF1-20MB tested in a series @ 0.50
gpm
(5) PCF1-20MB with RO feed water @ 0.50
gpm
1 Microsiemen = 1 Microhms/cm
FDA Grade Resin
FUNCTION STRUCTURE
Cation..............................................R-S0 3 -H+
Anion ................AR-N(CH 3 ) 2 (C 2 H 4 OH)+OH-
PHYSICAL FORM
IONIC FORM
PERCENT CONVERSION
Hydrogen ..............................99.9% Minimum
Hydroxide ................................95% Minimum
Applications:
• Circuit Board Printing
• Power Generating Equipment
• Pharmaceutical Use
• Medical/Laboratory Use
• Steam and Humidification
• Breeding Tanks
• Cosmetics
• Lasers
• Steam Processors
• Jet Water Sprayers
• Humidification Systems
• Boiler Make-up Water
• Recirculating/Cooling Towers
CAUTION: Filter must be protected against freezing which can causing cracking of the filter and water damage. For drinking water applications, do not use with
water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Do not use cartridges on equipment that
has an electric conductivity water level indicator.
NOTE: The above resin data is based on information obtained by Pentek Filtration. These data are believed to be reliable but do not imply any warranty or
performance guarantee. We recommend that the user determine performance by testing on his own processing equipment. We assume no liability or
responsibility for patent infringement resulting from the use of this product. The DI Resin cartridges are being designed for the following performance parameters.
Hydrotech
201