HY US 01 Introduction.qxp - Hydrotech

Commercial Membranes & Housings
FILMTEC Membranes
General Specifications (complete specification sheets available upon request)
Item # Model Applied Permeate Stabilized Maximum Typical
Pressure, Flow Rate, Salt Feed Flow Recovery
psig (bar) gpd (m 3 /d) Rejection, (%) Rate, gpm (m 3 /h) Rate (%)
2” Elements
92014 TW30-2013 225 (15.5) 100 (0.4) 99.0 3 (0.7) 5
92003 TW30-2026 225 (15.5) 220 (0.8) 99.0 3 (0.7) 10
2.5” Elements
92011 TW30-2514 225 (15.5) 175 (0.66) 99.0 6 (1.4) 5
92007 TW30-2521 225 (15.5) 300 (1.14) 99.0 6 (1.4) 8
92021 TW30-2540 225 (15.5) 650 (2.46) 99.0 6 (1.4) 15
92038 XLE-2540 100 (6.9) 770 (2.9) 99.0 6 (1.4) 15
4” Elements
92013 TW30-4014 225 (15.5) 475 (1.80) 99.0 17 (3.9) 5
92006 TW30-4021 225 (15.5) 900 (3.41) 99.0 17 (3.9) 8
92012 TW30-4040 225 (15.5) 2200 (8.33) 99.0 17 (3.9) 15
92036 XLE-4040 100 (6.9) 2400 (9.1) 99.0 14 (3.2) 15
92037 BW30-4040 225 (15.5) 2200 (8.33) 99.5 16 (3.6) 15
92039 BW30LE-4040 150 (10.3) 2000 (7.7) 99.0 16 (3.6) 15
Membrane Housings
Item # Vessel Size Material Port Connections, End Cap Maximum Pressure
inches
psig (bar)
92030 2514 Stainless Steel End, 1/4” PVC with U-Pin 300 (20.7)
92029 2521 Stainless Steel End, 1/4” PVC with U-Pin 300 (20.7)
92033 2540 Stainless Steel End, 1/4” PVC with U-Pin 300 (20.7)
92030 4040 Stainless Steel End, 1/2” PVC with U-Pin 300 (20.7)
92028 2540 PVC End, 1/4” PVC with U-Pin 225 (15.5)
92019 4040 PVC End, 1/2” PVC with U-Pin 225 (15.5)
Hydrotech
291