User Guide IQSocket IQSW-IP10

More documents

Recommendations

Info

©2011 IQtronic, Ltd Simply connect your <strong>IQSW</strong>-<strong>IP10</strong> with your computer or local Ethernet network using supplied cable and run the IQLocator.exe. After clicking to Scan button, a list of found devices will be displayed: In order to change device IP address, select particular device by clicking to the row and then click to button “SET IP addresses” button: Once you enter new IP address and click to “Set” button, a confirmation message “IP address was successfully set” will be displayed and new SCAN process will be performed to locate your device with new IP address. This IP address setting is temporary, valid until next device start. To make change IP permanent, it is necessary to use WEB management (see chapter 3.2.2) to save changes permanently. You can upgrade firmware similar way by clicking to “Upload firmware” button. Page 30 of 36
©2011 IQtronic, Ltd After browsing the target file containing new firmware and clicking to “Upload” button, a progress bar will be displayed. Green Link LED indicator will blink during upload process. When upload is finished, a confirmation message “Successful” will appear and now it is necessary to wait about 30seconds till internal firmware rewrite procedure finishes, during which the Power LED (red) will blinking fast. Then an automatic reboot of device will be performed and device is ready for use now. WARNING! Do not remove power during a firmware upgrade process, as it can render your device inoperational! Page 31 of 36
Page 1 and 2: User Guide IQSocket IQSW-IP10 Versi
Page 3 and 4: ©2011 IQtronic, Ltd Important info
Page 5 and 6: ©2011 IQtronic, Ltd 1.1 Product fe
Page 7 and 8: ©2011 IQtronic, Ltd 2.2 Powering I
Page 9 and 10: ©2011 IQtronic, Ltd 3.2.1 Status p
Page 11 and 12: ©2011 IQtronic, Ltd Explanation of
Page 13 and 14: ©2011 IQtronic, Ltd 3.2.3 Test rul
Page 15 and 16: ©2011 IQtronic, Ltd Number of pack
Page 17 and 18: ©2011 IQtronic, Ltd 3.2.4 Utility
Page 19 and 20: ©2011 IQtronic, Ltd 3.2.5 Control
Page 21 and 22: ©2011 IQtronic, Ltd Enter followin
Page 23 and 24: ©2011 IQtronic, Ltd Restart www.do
Page 25 and 26: ©2011 IQtronic, Ltd 3.3 SNMP IQsoc
Page 27 and 28: ©2011 IQtronic, Ltd In order to co
Page 29: ©2011 IQtronic, Ltd 3.4 Status dat
Page 33 and 34: ©2011 IQtronic, Ltd 5 Output socke
Page 35 and 36: ©2011 IQtronic, Ltd 7.1 Operation,

User Guide IQSocket IQSW-IP10

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?