MX510/MX512 Operator & Installation Manual - Simrad Professional ...

More documents

Recommendations

Info

Blank page 184 | Appendix E - Glossary | 184
Appendix F - Glossary AIS - Automatic Identification System. ALARM ALMANAC ALTITUDE AMBIENT A shipboard broadcast transponder system in which ships continually transmit their ID, position, course, speed and other data to other nearby ships and shoreline authorities on a common VHF radio channel. Message by which the navigator signals the occurrence of an event. The alarm is indicated by an audible tone and/or a message (or icon) on the display. Library of coarse satellite orbital characteristics used to calculate satellite rise times, set times, angles of eleva tion, etc. Almanac data is valid for 181 days. The height of the antenna relative to the WGS-84 elipsoid and geoidal height. Surrounding or encompassing environment. ANTENNA HEIGHT The height (over the waterline) in which the antenna is installed. This value is used in 2D mode only. ATMOSPHERIC PRESSURE See BAROMETRIC PRESSURE. APPARENT WIND ANGLE (AWA) The angle of the wind as measured on the moving vessel relative to the heading of the vessel. An AWA of 0° indicates a wind from straight ahead, whereas 180° indicates a wind from straight astern. An AWA of 90° indicates a wind perpendicular to the vessel from its starboard side. APPARENT WIND SPEED (AWS) The speed of the wind as measured on the moving vessel. Assigned Mode A transponder operates in an assigned mode if it is instructed by an external system to follow certain dictated rules, such as, which slots to use for transmission. Autonomous Mode AUX AZIMUTH BAUD BEARING BIT bps A transponder operates autonomously if it is independent of external control. Auxiliary Port – A communication port on the AIS transponder, which can be used for NMEA or RTCM, input. In satellite navigation, the angular distance measured on the horizon circle in a clockwise direction from the north point in the horizon to the satellite point in the horizon. Transmission rate unit of measurement for binary coded data (bit per second). The direction of one terrestrial point from another, expressed as angular distance from North, clockwise through 360°. Short form of Binary Digit. The smallest element of data in a binary-coded value. Bits Per Second. Appendix E - Glossary | 185
Page 1:
Manual Simrad MX510 and MX512 Navig
Page 4 and 5:
IMPORTANT NOTICE!! The MX51x is an
Page 6 and 7:
4 | MX510/MX512 Operator & Installa
Page 8 and 9:
NAV3 - Expanded Navigation Informat
Page 10 and 11:
Lighting - Display/Keyboard Light,
Page 12 and 13:
10 | Contents Blank page
Page 14 and 15:
12 | About GPS Navigation Blank pag
Page 16 and 17:
MX51x BR Beacon and Remote Configur
Page 18 and 19:
16 | DGPS Beacon System Blank page
Page 20 and 21:
Yellow/Green Solid GPS position upd
Page 22 and 23:
The Function Keys: The MX51x has 17
Page 24 and 25:
FUNCTION Keys You might have notice
Page 26 and 27:
Waypoint Bank (WPT1) where a symbol
Page 28 and 29:
NAV4 section which follows. You wil
Page 30 and 31:
NAV5 - Compass Display Screen The N
Page 32 and 33:
oute. Choose In Bank - allows you t
Page 34 and 35:
Creating a Multi-Waypoint Active Ro
Page 36 and 37:
8 You can then choose to select ano
Page 38 and 39:
Inserting Waypoints or Routes into
Page 40 and 41:
In this mode, the actual SOG is com
Page 42 and 43:
press ENT to select it. 4 Scroll le
Page 44 and 45:
10 Then press the EDIT function key
Page 46 and 47:
5 There are three methods to remove
Page 48 and 49:
Saving or Restoring Memory Data Usi
Page 50 and 51:
The CDU outputs these sentences in
Page 52 and 53:
3 Scroll down the menu to NMEA Out
Page 54 and 55:
Mark / MOB This is a dual function
Page 56 and 57:
Plot The PLOT1 screen displays grap
Page 58 and 59:
•• Show Lat/Lon Grid - No is th
Page 60 and 61:
Man Over Board The Man Over Board f
Page 62 and 63:
AUX3 - Not Used AUX4 - Sun Almanac
Page 64 and 65:
The tide measurement units can be d
Page 66 and 67:
Position There are three POS screen
Page 68 and 69:
provided so that you can log the mi
Page 70 and 71:
The GPS5 screen shows the position
Page 72 and 73:
Once you have entered the data for
Page 74 and 75:
Compass - External Compass Input &
Page 76 and 77:
Echo Sounder Connected - causes the
Page 78 and 79:
Whether a unit is a slave or repeat
Page 80 and 81:
LAN Output (NMEA 0183 OVER IP) This
Page 82 and 83:
LORAN-C Integration This feature wi
Page 84 and 85:
After the LORAN-C (Locus) feature i
Page 86 and 87:
XTE Alarm: Causes an alarm to sound
Page 88 and 89:
Most: NMEA Version - Some of the NM
Page 90 and 91:
Operation - General Setup and Contr
Page 92 and 93:
Printout (n) - Printer Output Contr
Page 94 and 95:
Security The Security screen allows
Page 96 and 97:
VGA This menu is available in the M
Page 98 and 99:
96 | Keypad & Display Descriptione
Page 100 and 101:
Item Component Part Number 1.0 MX52
Page 102 and 103:
Wire Preparation Procedure PWR/DATA
Page 104 and 105:
External Differential Connection Di
Page 106 and 107:
External Alarm Output The MX51x Ext
Page 108 and 109:
NMEA Output Sentences All sentences
Page 110 and 111:
MX51x LAN Crossover (Null) Cable Di
Page 112 and 113:
Troubleshooting Guide The MX51x is
Page 114 and 115:
6 Insert your USB device into the U
Page 116 and 117:
114 | Installation Blank page
Page 118 and 119:
Figure 5.3 - MX 510 Rear Connector
Page 120 and 121:
118 | Installation Figure 5.6 - Opt
Page 122 and 123:
120 | Installation Figure 5.9 - Ant
Page 124 and 125:
Figure 5.11 - MX512 Junction Box Di
Page 126 and 127:
124 | Installation Figure 5.14 MX51
Page 128 and 129:
Length Connector Connector 8 7 10 9
Page 130 and 131:
128 | Installation Figure 5.20 MX50
Page 132 and 133:
Figure 5.23 Multiple Control Config
Page 134 and 135:
132 | Installation Figure 5.25 - MX
Page 136 and 137: Length Connector Connector 10 9 8 7
Page 138 and 139: Figure 5.31 - MX512 Dual Control Co
Page 140 and 141: 138 | Installation Figure 5.34 - 44
Page 142 and 143: 140 | Installation Figure 5.36 - MX
Page 144 and 145: MX Series Smart D/GPS Antenna Recei
Page 146 and 147: NMEA listeners (all inputs): Insula
Page 148 and 149: Notes 146 | Appendix A - Datum list
Page 150 and 151: Then, the CDU will conduct a Keylig
Page 152 and 153: Antenna Reset Tools Special tools a
Page 154 and 155: Plotter Setup Data Base GPS Enginee
Page 156 and 157: 154 | Appendix C - Multiple unit co
Page 158 and 159: 156 | Appendix D - Demonstration mo
Page 160 and 161: Coastal Surveillance In coastal wat
Page 162 and 163: GPS satellite message. Thus, GPS pl
Page 164 and 165: MX512/AIS the Total Shipboard GPS/D
Page 166 and 167: Note: A total of 35 lines are avail
Page 168 and 169: How to change transponder settings
Page 170 and 171: 5 - See above 4 - Carrying Carrying
Page 172 and 173: AIS 2 - Remote Ship List This displ
Page 174 and 175: Display Field Descriptions: OUTPUT
Page 176 and 177: -- -- -- -- Latitude difference sho
Page 178 and 179: AIS 9 - AIS STATUS This display sho
Page 180 and 181: Automatic Identification System Ins
Page 182 and 183: Figure E-3: MX535A with MX512 CDU a
Page 184 and 185: Figure E-5: 50-Pin Cable Assembly (
Page 188 and 189: CENTRAL MERIDIAN The meridian (see
Page 190 and 191: ELEVATION ANGLE ELIPSOID ENTER The
Page 192 and 193: HEALTH IEC IMO See SATELLITE HEALTH
Page 194 and 195: PARITY CONVENTION P-CODE In checkin
Page 196 and 197: SIGNAL-TO-NOISE RATIO (S/N) S/N SOF
Page 198: VTS WAYPOINT Vessel Traffic Service
show all

MX510/MX512 Operator & Installation Manual - Simrad Professional ...

Create successful ePaper yourself

Delete template?

Save as template?