Metos Marine Galley and Laundry Equipment

METOS PRM PRE-WASH MACHINE
The conveyor from the Nordiefl ex sorting
unit takes the basket to the prewash
machine and then further to the
rack conveyor machine.
Metos pre-wash machine is excellent choice when manual
pre-washing is not an option or when wash power (contact
time) needs to be improved. Metos pre-wash machine is fi tted to
Nordiefl ex returning and sorting units. The Nordiefl ex conveyor from
the sorting area continues through the pre-rinse machine all the way
until the rack conveyor machine enabling easy and effi cient working
in dish handling.
Metos pre-wash machine is economical to operate as the water used is recycled.
The unit can be connected either to fresh water or water can be supplied from
Metos ICS+ rack conveyor machine. In both cases the running costs are extremely
low thanks to the recycling principle in the pre-wash machine. When choosing
water supply from the ICS+ machine, the only fresh water consumption is the
initial fi lling of the pre-wash machine (30 litres).
The dishes are rinsed in the pre-wash machine with water of temperature 40°C
(small concentration of detergent recommendable). Food residues are rinsed
from the dishes in the pre-wash machine. This improves the entire washing result
and helps to keep the water in the tanks of the dishwashing machine cleaner.
In installations where the length of the actual rack conveyor machine is limited
(small dish rooms), the pre-wash machine can be installed in the bend before
the machine thus taking in use every inch in the dish room and at the same time
helping to reach better washing result.
The pre-wash machine is easy to install and all service can be done from the
front. The machine is available in two models: WD-PRM 90 for 90° bend installation
or WD-PRM 60 for straight position.
Metos PRM-pre-wash machine Dimensions mm
WD-PRM 90 bend L-R 950x950x1700
WD-PRM 60 straight L-R 600x670x1700
WD-PRM 90 bend R-L 950x950x1700
WD-PRM 60 straight R-L 600x670x1700
PRM options
Conveyor installation kit for PRM 90 for EasyClean and hygienic chain
Conveyor installation kit for PRM 60 for EasyClean and hygienic chain
Machine driven straight section for PRM60 E, 1200 mm
Machine driven straight section for PRM60 ICS+, 1200 mm
Machine driven straight section for PRM60 E, 900 mm
Machine driven straight section for PRM60 ICS+, 900 mm
Installation drawing on page 262.
Technical data
Connection power 3 x 400V 0,80 kW 10A
Pump 0,75 kW
Flow 350 litres/min.
Water connection CW R 1/2”
Water connection WW R 1/2”
Water connection from rack conveyor (option) PP pipe 50 mm
Drain PP pipe 50 mm
Tank volume 30 litres
Effi cient double strainers The wash arms are easy to
release for cleaning.
| 203