Crossover Main Replacement - Coke Oven Managers Association

More documents

Recommendations

Info

Installing the new Crossover Mains Installation of the new horizontal section Scaffolding towers erected on either end of the crossover proved a safe working area for the installation team to carefully guide the new pipe into place and install the new gaskets. 26
Installing the new Crossover Mains Installation of Bend Section The final section to be fitted is the bend. The bend section was cut to suit, allowing for the difference in the new installation fitting to the existing pipe work that is still operational and carrying hot gas. The bend was measured and tacked on site then removed backed to a workshop for completion. 27
Page 1 and 2: Matthew John Crossover Main Replace
Page 3 and 4: Introduction After 33 years of unin
Page 5 and 6: Introduction The first two options
Page 7 and 8: Planning Phase Health and Safety Sa
Page 9 and 10: Planning Phase Assembly Drawings An
Page 11 and 12: Preparation Phase Jacking Steelwork
Page 13 and 14: Preparation Phase Spreader beam Due
Page 15 and 16: Preparation Phase Interconnecting p
Page 17 and 18: Preparation Phase Expansion Joint T
Page 19 and 20: Crossover Main Replacement Isolatin
Page 21 and 22: Crossover Main Replacement Removal
Page 23 and 24: Crossover Main Replacement Horizont
Page 25: Installing the new Crossover Mains
Page 29 and 30: Installing the new Crossover Mains

Crossover Main Replacement - Coke Oven Managers Association

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?