HC25 AT Command Set - Portech.com.tw

HC25 AT Command Set
8.7 AT^SMONP
s
8.7 AT^SMONP Monitor neighbour cells
The AT^SMONP supplies information of neighbour cells. To retrieve the information use the execute command.
Syntax
Test Command
AT^SMONP=
Response(s)
OK
Exec Command
AT^SMONP
Response(s)
See: Section 8.7.1, AT^SMONP responses
OK
Reference(s) PIN USB0-MDM USB0-APP Last
SIEMENS - + + -
Notes
• Due to the fact that not all necessary information of the neighbour cells can be decoded during a connection,
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
• The neighbour cells have the same PLMN as the serving cell.In case of searcing for a network the serving
cell can change and the ME shows different sets of neighbour cells depending on the PLMN of the serving
cell.
• In case of a 2G serving cell the ME shows 2G and 3G neighbour cells. If 3G is available then no neighboring
2G cells are shown.
• Please note that the output will be changed in future releases. Unsupported parameters are signed as "-" .
8.7.1 AT^SMONP responses
Response of AT^SMONP:
2G:
ARFCN 1 ,BCCH 1
ARFCN 2 ,BCCH 2
...
ARFCN n ,BCCH n
3G:
UARFCN 1 ,PSC 1 ,EC/n0 1 ,RSCP 1
UARFCN 2 ,PSC 2 ,EC/n0 2 ,RSCP 2
...
UARFCN n ,PSC n ,EC/n0 n ,RSCP n
Example:
2G:
HC25_ATC_V01.200 Page 127 of 290 7/25/07
Confidential / Released