HC25 AT Command Set - Portech.com.tw

HC25 AT Command Set
10.9 AT+CGQREQ
s
10.9 AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Test Command
AT+CGQREQ=
Response(s)
+CGQREQ: , (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
Read Command
AT+CGQREQ
Response(s)
+CGQREQ: [, , , , , ]
[+CGQREQ: , , , , , ]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=[, [, [, [, [, ]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN USB0-MDM USB0-APP Last
3GPP 27.007 + + + -
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context for which a QOS was explicitly specified.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the context identification parameter, .
A special form of the set command, +CGQREQ= causes the requested profile for context number
to become undefined.
Parameter Description
(num)
Parameter specifies a particular PDP context definition. The parameter is also used in other PDP context-related
commands.
1...16
(num)
Precedence class
[0] network subscribed value
1 High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
HC25_ATC_V01.200 Page 174 of 290 7/25/07
Confidential / Released