HC25 AT Command Set - Portech.com.tw

HC25 AT Command Set
10.6 AT+CGQMIN
s
10.6 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Syntax
Test Command
AT+CGQMIN=
Response(s)
+CGQMIN: , (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
ERROR
+CME ERROR
Read Command
AT+CGQMIN
Response(s)
+CGQMIN: [, , , , , ]
[+CGQMIN: , , , , , ]
[+CGQMIN: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGQMIN=[, [, [, [, [, ]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN USB0-MDM USB0-APP Last
3GPP 27.007 + + + -
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each context for which a QOS was explicitly specified.
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the context identification parameter, .
A special form of the set command, AT+CGQMIN= causes the minimum acceptable profile for context
number to become undefined. In this case no check is made against the negotiated profile.
Parameter Description
(num)
Parameter specifies a particular PDP context definition. The parameter is also used in other PDP context-related
commands.
1...16
(num)
Precedence class
[0] network subscribed value
HC25_ATC_V01.200 Page 165 of 290 7/25/07
Confidential / Released