HC25 AT Command Set - Portech.com.tw

HC25 AT Command Set
16.9 AT^SRTC
s
(num)
Type or number of ring tone melody. You have a choice of ring tone melody or mute. Ring tone melody will be
played from the audio output. =0 is only intended for muting.
0 (D) No ringing alert melody.
1 Melody #1 active.
2 Melody #2 active.
3 Melody #3 active.
4 Melody #4 active.
5 Melody #5 active.
6 Melody #6 active.
7 Melody #7 active.
8 Melody #8 active.
9 Melody #9 active.
(num)
The volume of ring tone melodies varies from 0 dB to mute.
0 (D) Mute.
1 Volume level 1, set to -12dB.
2 Volume level 2, set to -8dB.
3 Volume level 3, set to -4dB.
4 Volume level 4, set to 0dB.
Note
• The ring tone factory setting are AT^SRTC=0,0,0 (ring tones for incoming voice call is muted), AT^SRTC=1,0,0
(ring tones for incoming fax call is muted) and AT^SRTC=2,0,0 (ring tones for incoming SMS is muted). To
activate ring tones please use the write command. After applying a firmware update or a new start of module
please activate ring tone again because it is stored in the volatile memory.
When the incoming fax call event was configured before with =0 it's possible to mute a running
tone (for example during a incoming call) by calling of AT^SRTC execution command. Otherwise please call
AT^SRTC execution command two times.
HC25_ATC_V01.200 Page 263 of 290 7/25/07
Confidential / Released