HC25 AT Command Set - Portech.com.tw

HC25 AT Command Set
9.5 AT+CCFC
s
(str)
String type phone number of forwarding address in format specified by . If you select = 3, the
phone will be registered in the network. This allows you to disable / enable CF to the same destination
without the need to enter the phone number once again. Depending on the services offered by the provider the
registration may be mandatory before CF can be used. The number remains registered in the network until you
register another number or erase it using = 4.
(num)
Type of address octect
145 dialing string includes international access code character '+'
129 otherwise
(num)
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication service
or bearer service group as defined in "GSM 02.04"
1 voice
2 data
2 (data) comprises all those values between 16 and 128, that
are supported both by the network and the MS. This means, a setting made for
2 applies to all remaining data classes (if supported). In addition, you
can assign a different setting to a specific class. For example, you can activate
call forwarding for all data classes, but deactivate it for a specific data class.
4 fax
8 SMS
16 data circuit sync
32 data circuit async
64 dedicated packet access
128 dedicated PAD access
1...[7]...255 combination of some of the above classes. For example, the default setting 7
represents the sum of the integers 1, 2 and 4 (CF for voice, data and fax). The
value 255 covers all classes. If the parameter is omitted, the default
value 7 is used.
(str)
String type phone number of sub address in format specified by .
(num)
Type of sub-address octect
145 international access code character '+'
129 otherwise
(num)
5...[20]...30 Time to wait before call is forwarded, rounded to a multiple of 5 sec. (only for
=no reply)
(num)
0 Call forwarding not active
1 Call forwarding active
HC25_ATC_V01.200 Page 138 of 290 7/25/07
Confidential / Released