MikroTik RouterOS™ v2.9

• none - do nothing special, do not combine packets
• best-fit - put as much packets as possible in one frame, until the framer-limit limit is met, but
do not fragment packets
• exact-size - put as much packets as possible in one frame, until the framer-limit limit is met,
even if fragmentation will be needed (best performance)
• dynamic-size - choose the best frame size dynamically
name (name) - reference name of the interface
Notes
Such settings as enable-polling, framer-policy and framer-limit are relevant only on Access
Point, they are ignored for client devices! The client automatically adapts to AP settings.
WDS for Nstreme protocol requires using station-wds mode on one of the peers. Configurations
with WDS between AP modes (bridge and ap-bridge) will not work.
Example
To enable the nstreme protocol on the wlan1 radio with exact-size framing:
[admin@MikroTik] interface wireless nstreme> print
0 name="wlan1" enable-nstreme=no enable-polling=yes framer-policy=none
framer-limit=3200
[admin@MikroTik] interface wireless nstreme> set wlan1 enable-nstreme=yes \
\... framer-policy=exact-size
Nstreme2 Group Settings
Home menu level: /interface wireless nstreme-dual
Description
Two radios in nstreme-dual-slave mode can be grouped together to make nstreme2 Point-to-Point
connection. To put wireless interfaces into a nstreme2 group, you should set their mode to
nstreme-dual-slave. Many parameters from /interface wireless menu are ignored, using the
nstreme2, except:
• frequency-mode
• country
• antenna-gain
• tx-power
• tx-power-mode
• antenna-mode
Property Description
arp (disabled | enabled | proxy-arp | reply-only; default: enabled) - Address Resolution Protocol
Page 230 of 615
Copyright 1999-2005, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.