MikroTik RouterOS™ v2.9

• using-local-clock - using local clock as time source (server enabled while client disabled)
Example
To enable the NTP client to synchronize with the 159.148.60.2 server:
[admin@MikroTik] system ntp client> set enabled=yes primary-ntp=159.148.60.2
[admin@MikroTik] system ntp client> print
enabled: yes
mode: unicast
primary-ntp: 159.148.60.2
secondary-ntp: 0.0.0.0
status: synchronized
[admin@MikroTik] system ntp client>
Server
Home menu level: /system ntp server
Property Description
broadcast (yes | no; default: no) - whether NTP broadcast message is sent to 255.255.255.255
every 64s
enabled (yes | no; default: no) - whether the NTP server is enabled
manycast (yes | no; default: yes) - whether NTP server listens for multicast messages sent to
239.192.1.1 and responds to them
multicast (yes | no; default: no) - whether NTP multicast message is sent to 224.0.1.1 every 64s
Notes
NTP server activities only when local NTP client is in synchronized or using-local-clock mode.
If NTP server is disabled, all NTP requests are ignored.
If NTP server is enabled, all individual time requests are answered.
CAUTION! Using broadcast, multicast and manycast modes is dangerous! Intruder (or simple
user) can set up his own NTP server. If this new server will be chosen as time source for your
server, it will be possible for this user to change time on your server at his will.
Example
To enable NTP server to answer unicast requests only:
[admin@MikroTik] system ntp server> set manycast=no enabled=yes
[admin@MikroTik] system ntp server> print
enabled: yes
broadcast: no
multicast: no
manycast: no
[admin@MikroTik] system ntp server>
Time Zone
Page 503 of 615
Copyright 1999-2005, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.