Download the full catalog - Schaff Piano Supply Co.

134
REPAIR ITEMS
3505
3506
HAMMER SHANK REPAIR SLEEVES
A quick and permanent method in the repair of broken
hammer shanks. Choice of two styles.
No. 3505 - A seamless brass tube with very thin wall. Each
No. 3506 - A seamless metal tube with split that can be
drawn tight against hammer shank. Each
PENISTEN WHIPPEN REPAIR PIN
For repairing whippens that have broken
at or above the pin hole. A necessity for
repairing obsolete whippens.
No. 298 - Each
REPAIR FLANGES
For replacing in the solid flange
rail section. Heavy brass.
No. 517 - Each
BRASS FLANGE ACCESSORIES
REPAIR CLIPS
Necessary when the tongue has broken
at the screw hole. Heavy brass.
No. 513B - Each
REPAIR CLIPS
Special for Kimball pianos. Heavy brass.
No. 513KA - Each
BUTT PLATES
Extra heavy brass; without threads. For
Kimball pianos.
No. 518-1/2 - Each
BUTT PLATES
Extra heavy brass; with screws.
No. 518A - Each
HAMMER RAIL REPAIR SPRINGS
Quickly installed in any upright action
without moving the spring rail by using an
awl (or 1/16” drill), screw holder and screw
driver. Comes with screws.
No. 1519A - For Uprights. Each
No. 1519B - For Spinets. Each
REPAIR DAMPER SPRINGS
Held in place by the flange screw. Simply back
the screw out two or three turns, insert spring
and tighten screw to complete installation.
No. 1538A - For Uprights. Each
No. 1538B - For Spinets. Each
REGULATING SCREW REPLACEMENT
For quick replacement of regulating screws and
buttons. Removal of action not necessary.
No. 1539 - Each
REPAIR CLIPS
For use when the tongue is broken at the groove.
One-half of the old groove is used, and the broken
part replaced by the repair clip. Heavy brass.
No. 513A - Each
REPAIR CLIPS
Special for Kimball pianos when the tongue has
broken at the screws. Heavy brass.
No. 513KB - Each
REPAIR CLIP AND BUTT
PLATE SCREWS
No. 518S - Each
BRASS FLANGE RAIL DUPLICATION
Now a duplication service for brass flange rails! We can duplicate all
1” rails only, from your sample rail or a carefully marked pattern.
When sending a paper pattern, be sure to accurately show the center line of each butt, the overall length of each section and the
exact location of the mounting holes. Flange sections are furnished complete with butt plates and screws. Single Sections.
No. 595 - Each