Download the full catalog - Schaff Piano Supply Co.

GAUGES
RENNER HAMMER ANGLE GAUGE
One size measures tenor and treble
hammer angles, the other bass angles.
Gauge is made of lightweight plastic
that is 4-1/2" long X 2-3/4" wide.
German made.
No. 289 - Hammer Angle Gauge. Each
HAMMER ANGLE PROTRACTOR
A precision tool for quickly and accurately measuring upright
or grand hammer angles. Particularly useful for technicians
who bore their own hammers. Packed in protective pouch.
Stainless steel, measures 0-180 degrees.
No. 3153 - Hammer Angle Protractor. Each
DEPTH GAUGE
Good quality, low priced depth
gage. 6” rule measures 32nds on
one side, 64ths of an inch on the other side. Can be set to
30, 45 or 60 degree angles.
No. 3211 - Depth Gauge. Each
STARRETT MICROMETER
Measures 0 to 1 inch by 1/1000. Easy to read, satin chrome
finish. Micrometer is 4-1/4” long and has a locking device
for a fixed measurement. The Starrett name assures accuracy
and a long life.
No. 3338 - Starrett Micrometer. Each
STARRETT DIGITAL MICROMETER
A precision micrometer that has large, easy to read counter
numerals for quick and error free readings. There is a ratchet
stop and spindle lock for repetitive, accurate measurements.
Digital readings to 1 inch by .001; .0001 readings made by
graduation readings on the sleeve. 5-1/2” long.
No. 4044 - Digital Micrometer. Each
DIGITAL MICROMETER
This imported economical digital micrometer is ideal for
occasional use. Measures 0-1". Case included.
No. 3299 - Digital Micrometer. Each
DIAL CALIPER
This reinforced plastic, Swiss made caliper measures 4
ways: inside, outside, depth and step readings. The easy to
read color coded dial is graduated in .01 and 64ths with
inch and mm on the bar scale. Caliper measures 0 to 5”
and is 8-1/2” long. Comes with a plastic case.
No. 4046 - Dial Caliper. Each
VERNIER CALIPER
This 8-1/2” long, stainless steel, dull chrome finish caliper
has a capacity from 0-6” for reading inside, outside and
depth measurements. Bottom of scale reads .001”, the top
12/0 mm. On the back side there is a comparison
reference table for metric, fractions and decimal.
Automatic thumb lock and beveled jaws can be used for
thread measurements.
No. 179 - Vernier Caliper. Each
POCKET CALIPER
Made of plastic reinforced with fiberglass, this 4-1/2” long
caliper has a 3” outside measurement capacity. Both inside
and outside readings are graduated in 32nds and mm. The
reverse side has a 4” ruler graduated in 16ths. This is an
excellent tool case gauge.
No. 4045 - Pocket Caliper. Each
75