Download the full catalog - Schaff Piano Supply Co.

REGULATING TOOLS
SLOTTED SCREWDRIVER
This chrome plated screwdriver has 3/16” diameter shank
and 1/4” wide blade.
No. 32C - Screwdriver, 8” long. Each
PHILLIPS SCREWDRIVER
The No. 2 phillips screwdriver has a 1/4” diameter shank and
is finished in polished steel.
No. 33A - Phillips Screwdriver, 8” long. Each
PHILLIPS SCREWDRIVER
This No. 1 phillips screwdriver has a 3/16” shank, is 5-1/2”
long and is chrome plated.
No. 38 - Phillips Screwdriver. Each
GRAND SCREWDRIVER
Tool is 5” long with both the shank diameter and blade width
being 1/8”. Polished steel.
No. 4105 - Grand Screwdriver. Each
SCREWDRIVER
This chrome plated, 8” long screwdriver has a 1/4”
diameter shank and an extra wide 3/8” blade for use
with larger screws.
No. 90 - Screwdriver. Each
FLANGE SCREWDRIVER - SLOTTED
This is a special designed screwdriver for hard to reach
action screws. Blade is 3/8” wide with shank diameter of
1/4” tapering to 5/32”. Chrome plated.
No. 34 - Flange Screwdriver, 8” long. Each
No. 35 - Flange Screwdriver, 4-1/2” long. Each
FLANGE SCREWDRIVER - PHILLIPS
The thin shank will permit passing the jack to reach upright
flange screws. May also be used for damper screws. Do not
use for general screwdriving, as shank is not sufficiently strong.
1/8” shank, 8” long, blade 1/4” wide.
No. 3115 - Screwdriver Blade for Flange Phillips Screws. Each
REGULATING SCREWDRIVER
Chrome plated tool has 5/16” wide opening for turning large
regulating screws. 1/8” diameter shank allows for easy access
into piano action.
No. 67 - Regulating Screwdriver, 5” long. Each
No. 67A - Regulating Screwdriver, 7” long. Each
No. 67B - Regulating Screwdriver, 12” long. Each
GRAND SCREWDRIVER
A specially designed tool with a 3/16” wide opening
to regulate grand key rail prop nuts. Having a 1/4”
diameter shank and measuring 8” long, this screwdriver
is chrome plated.
No. 37 - Grand Screwdriver. Each
SPOON BENDER
For ease in adjusting the spoon, the angle of this tool
facilitates getting under and around the whippens without
removing the piano action. Being 6” long and chrome plated,
this spoon bender can be used on direct blow type actions.
No. 85 - Spoon Bender. Each
SPOON BENDER
For use in reaching under key beds on spinet drop action
pianos. 12” long, chrome plated.
No. 87 - Spoon Bender. Each
SPOON AND WIRE BENDER
No. 3114 - Spoon and Wire Bender. Each
SPOON AND WIRE BENDER
New slender design 6-1/2” long.
No. 3142 - Spoon and Wire Bender. Each
SPOON AND WIRE BENDER
Same style as No. 3142 but notched on one end to
fit combination handle.
No. 3142A - Spoon and Wire Bender. Each
SPOON AND DAMPER WIRE BENDER
New design with double right angle bend. Notched
for combination handle.
No. 3143 - Spoon and Damper Wire Bender. Each
41