Download the full catalog - Schaff Piano Supply Co.

BRIDGE PINS AND REPAIR ITEMS
For...Bridges...Pin Planks...Sounding Boards
BRIDGE PINS
Coppered, with one end pointed, other
end round, 1” long
No. 551-6 (Dia .076) Per 100
No. 551-7 (Dia .086) Per 100
No. 551-8 (Dia .096) Per 100
No. 551-9 (Dia .109) Per 100
No. 551-10 (Dia .135) Per 100
GARFIELD PIN BLOCK RESTORER
This success of GARFIELD PIN
BLOCK RESTORER has brought about
many imitations. There is only one
original and genuine GARFIELD
Restorer - made by a formula
developed by Wm. M. Garfield after
40 years experience as a tuner and
technician. For your own protection,
insist upon it. GARFIELD’S PIN
BLOCK RESTORER has these
important features: It comes in liquid
form...easy to apply with a syringe or
eye dropper. It penetrates into the
cells of the wood to restore its
holding power. It contains no oil...will
not evaporate. Its effectiveness
improves with age...in one week the
pins are tight enough to permit
tuning. It prevents rust...will not affect
glue. 4 oz bottle. Must be diluted with
an equal amount of Denatured Alcohol.
No. 1346 - Each
LUNSFORD’S INSTANT PIN-TITE
Tightens in MINUTES, restores pin
block permanently, preserves and
protects wood, remains dry, tune within
hour - 20 minutes in many cases, and
also tightens instantly many action
parts, cases, benches, and stripped
screw holes. 8 oz Bottle.
No. 1347 - Each
Nickel Plated, with one end pointed,
other end round, 1” long
No. 55IN-6 (Dia .076) Per 100
No. 55IN-7 (Dia .086) Per 100
No. 55IN-8 (Dia .096) Per 100
No. 55IN-9 (Dia .109) Per 100
Coppered with round ends, 3/4” long
No. 543-6 (Dia .076) Per 100
No. 543-7 (Dia .086) Per 100
No. 543-8 (Dia .096) Per 100
No. 543-9 (Dia .109) Per 100
SPRUCE SHIMS
For filling cracks in piano sound board.
Fine quality spruce. 30” long.
No. 943 - 3/16" approximate width at top. Each
No. 943A - 1/8" approximate width at top. Each
SOUND BOARD BUTTONS
Made of maple with plank grain. For
#8, and #10 screws. 1” diameter.
No. 354 - Each
546
547
548
SOUNDING BOARD TOGGLES
For fastening cracked sounding boards. Quality toggles with
marked end enabling direction of flange to be seen when
installing. NOTE: It is the vibration of the soundboard against
the rib that causes the buzz when certain notes on the piano
are sounded. These toggles are easy to install; can be used
on grands as well as uprights; bore 1/4” hole through the rib
and sounding board at the crack. Insert toggle so the anchor
arm will drop with straight side against the board. Adjust so
it extends directly across the crack. Then tighten nut. The line
on threaded end indicates the position of arm. Toggles are
available with long, medium and short arms. Specify when
ordering.
No. 546 - Short arm. Each
No. 547 - Medium arm. Each
No. 548 - Long arm. Each
97