Download the full catalog - Schaff Piano Supply Co.

PLIERS
ACTION REGULATING PLIERS
These compound leverage pliers have concave-convex
jaws for bending backcheck, damper or bridle wires.
Pliers are 7-1/2” long, nickel plated.
No. 246 - Action Regulating Pliers. Each
ORIGINAL FACTORY TYPE WIRE BENDING PLIERS
Considerable time was spent by Schaff to research and test a
new method of casting for these pre-World War I designed
wire bending pliers. Made of stainless steel these pliers,
originally made for piano factory use, have great leverage
because of their 9” length and jaw design. A lifetime tool.
No. 244 - Wire Bending Pliers. Each
BACKCHECK WIRE BENDING PLIERS
Parallel sliding action permits positive and accurate forward
and backward bending of either backcheck or bridle wires.
Plier is nickel plated and 6” long.
No. 5502 - Wire Bending Pliers. Each
CENTER PIN NIPPERS
These end cutting nippers are ideal for cutting center pins.
NOT RECOMMENDED FOR PIANO WIRE. Pliers are 4-1/2”
long and have spring loaded rubber grip handles.
(German made)
No. 231 - Center Pin Nippers. Each
CENTER PIN NIPPERS
The diagonal, flush cut jaws of this plier are well suited for
cutting center pins during repinning. NOT RECOMMENDED
FOR PIANO WIRE. Pliers are 5” long and have spring loaded
cushion grip handles.
No. 230 - Center Pin Nippers. Each
MAXI-SHEAR FLUSH CUTTER
Made of highest grade .125” thick high carbon steel. 6” wire
cutter with rubber grips and glare eliminating black finish.
Excellent for use on center pins and soft wire.
No. 215 - Flush Cutter. Each
HAMMER SHANK CUTTERS
Razor sharp blade allows for fast, easy and efficient cutting to
length of upright hammer shanks. 5” long, chrome plated
tool has spring loaded handles for easy cutting action.
No. 237 - Hammer Shank Cutters. Each
HAMMER SHANK CUTTERS
6” long shears that will cut hammer shanks quickly and
efficiently. Also for splitting hammer moldings when
removing old hammers from shanks.
No. 3207 - Hammer Shank Cutters. Each
67