VL1000 ERS Luminaire User's Manual - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - <strong>VL1000</strong> <strong>ERS</strong> LUMINAIRE USER’S MANUAL Hanging the Ballast (Arc Models Only) The external ballast unit included with arc models will need to be installed near the luminaire. In order for the lamp cable to be connected, the ballast must be placed within 40 inches (1m). The top panel provides one mounting hole for attaching a truss hook or other mounting hardware as required. (Compatible truss hooks are available from different manufacturers for your particular needs.). To install truss hooks (if required): Step 1. Attach truss hook as shown below (Figure 2-11). Step 2. Tighten hardware securely. WARNING: Attach truss hooks securely. Hook Hardware (not provided) Truss Hook (not provided) Figure 2-11: Example Ballast Truss Hook Installation 22 04-Apr-03 02.9663.0001 D
INSTALLATION : INSTALLATION PROCEDURES 2 To hang arc ballast in truss: Step 1. Lift ballast into mounting position. Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g. wing bolt) is properly tightened and that ballast is fully supported. Step 3. Attach safety cable (as required) as follows: a. Connect end of cable to attachment point at one side of ballast. b. Loop at least once around pipe and attach other end at second point. Safety Cable: Recommended for all hanging installations. May be required by local codes. 4.54" (11.5 cm) 13.43" (34.1 cm) 11.56" (29.4 cm) Figure 2-12: Ballast Installation 02.9663.0001 D 04-Apr-03 23
Page 2 and 3: VARI❋LITE ® is a trademark owned
Page 4 and 5: VARI❋LITE® - VL1000 ERS LUMINAIR
Page 90 and 91:
VARI❋LITE® - VL1000 ERS LUMINAIR
show all

VL1000 ERS Luminaire User's Manual - Vari-Lite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?