VL1000 ERS Luminaire User's Manual - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - VL1000 ERS LUMINAIRE USER’S MANUAL Self Tests Running Parameter Tests The luminaire is capable of running self tests by using the TEST menu functions. When running tests on multiple luminaires, a loopback connector is required at the master luminaire (first in link) and a male termination connector is required at the last luminaire in the link. Refer to page 14 for more information regarding the construction of these connectors. Note: After 10 seconds of inactivity, the menu display will change to the default state showing the address. To connect luminaires for simultaneous testing: Step 1. At first luminaire in link, install loopback connector into DATA IN XLR connector. Step 2. At last luminaire, install male termination connector into DATA THRU XLR connector. Step 3. At master luminaire Menu Display, press [Menu]. First luminaire containing software version to download Luminaire 1 requiring update Luminaire 2 requiring update Data Thru Data Thru Loopback Connector Male Termination Connector Figure 4-1: Hardware Setup To run tests: Step 1. Press [Menu]. Step 2. Press [Up] / [Down] arrows until Test appears. Press [Enter]. Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to “Menu System Function Chart” on page 55 for a complete list of test parameters which can be chosen. Step 4. Press [Enter] to run test. Step 5. Press [Menu] to stop test at any time. 60 04-Apr-03 02.9663.0001 D
MENU SYSTEM : SELF TESTS 4 Movement Disable The Movement option allows pan and tilt to be disabled so that the luminaire can be placed in any position for testing without movement occurring. In order to regain full control of the luminaire, Movement will need to be enabled after testing. Note: When using the Movement option, pan and tilt will be disabled for all the luminaires that are linked. To set movement option: Step Step Step Step Step 1. Press [Menu]. 2. Press [Up] / [Down] arrows until Config appears. Press [Enter]. 3. Press [Up] / [Down] arrows until Pan/Tilt appears. Press [Enter]. 4. Movement will be displayed. Press [Enter]. 5. Use [Up] / [Down] arrows to select Enable or Disable. Press [Enter] to select. 02.9663.0001 D 04-Apr-03 61
Page 2 and 3:
VARI❋LITE ® is a trademark owned
Page 4 and 5:
VARI❋LITE® - VL1000 ERS LUMINAIR
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29: VARI❋LITE® - VL1000 ERS LUMINAIR
show all

VL1000 ERS Luminaire User's Manual - Vari-Lite

Create successful ePaper yourself

Delete template?

Save as template?