U.S. DEPARTMENT OF TRANSPORTATION - SaferCar.gov

More documents

Recommendations

Info

TP-P572-U-00 CHECK SHEET NO. U7 (Continued) ABDOMEN IMPACT TEST (S572.186) Figure 27. Abdomen Impact Face Conduct Test, Collect Data and Verify Performance __10 __11 __12 __13 __14. __15. Record the room temperature and humidity in Table U8. Verify that the temperature and relative humidity meets specification by indicating “Pass” or “Fail” in the far right column. The pendulum is aligned so that at contact with the abdomen, its longitudinal axis is perpendicular ±0.5º to the midsagittal plane of the dummy and the impact face is centered on the abdomen’s middle load measuring sensor within 5 mm. Release the pendulum such that it strikes the dummy’s thorax with an impact speed of 4.0 ± 0.1 m/s. Record the impactor acceleration and digitally filter at SAE J211 CFC180. Record the abdomen forces from the three load cells and digitally filter at SAE J211 CFC 60. Verify that the maximum of the sum of the forces of the three abdominal load sensors is not less than 2200 N and not more than 2700 N occurring between 10 ms and 12.3 ms. The calculated sum of the three load cell forces must be concurrent in time. __16. Verify that the maximum impactor force (e.g., impactor acceleration multiplied by its mass) is not less than 4000 N and not more than 4800 N occurring between 10.6 ms and 13.0 ms. -32-
TP-P572-U-00 CHECK SHEET NO. U7 (Continued) ABDOMEN IMPACT TEST (S572.186) Table U8. Abdomen Impact Test Tested Parameter Units Specification Result Head Assembly Soak Time Minutes ≥240 Temperature - Max C 20.6 to 22.2 During Soak Min C Humidity - During Soak Max % 10.0 to 70.0 Min % Temperature – During test C 20.6 to 22.2 Humidity – During test % 10.0 to 70.0 Peak Impactor Force kN 4.0 to 4.8 Time of Peak Impactor Force ms 10.6 to 13.0 Sum of Abdomen forces kN 2.2 to 2.7 Time ms 10 to 12.3 Pass/ Fail __________________________________ Signature ____________________ Completion Date -33-
Page 1 and 2:
Rev. 09/19/2012 SEPTEMBER 2012 U.S.
Page 3 and 4:
SINCAP MDB LABORATORY TEST PROCEDUR
Page 5 and 6:
SINCAP MDB LABORATORY TEST PROCEDUR
Page 7 and 8:
SINCAP MDB - 2 1. PURPOSE AND APPLI
Page 9 and 10:
SINCAP MDB - 4 2.3. TEST VEHICLE AS
Page 11 and 12:
SINCAP MDB - 6 schedule in cases of
Page 13 and 14:
SINCAP MDB - 8 (10) The position of
Page 15 and 16:
SINCAP MDB - 10 Figure 2 - Typical
Page 17 and 18:
SINCAP MDB - 12 D. A written calibr
Page 19 and 20:
SINCAP MDB - 14 before the MDB cont
Page 21 and 22:
SINCAP MDB - 16 shows not only curt
Page 23 and 24:
SINCAP MDB - 18 (2) Measure the dis
Page 25 and 26:
SINCAP MDB - 20 D. BARRIER PHOTOGRA
Page 27 and 28:
SINCAP MDB - 22 NOTE: The test labo
Page 29 and 30:
SINCAP MDB - 24 9.8 STILL PHOTOGRAP
Page 31 and 32:
SINCAP MDB - 26 No. 050 - Post-Test
Page 33 and 34:
SINCAP MDB - 28 NOTE: The numbering
Page 35 and 36:
SINCAP MDB - 30 (1) NHTSA Number (s
Page 37 and 38:
SINCAP MDB - 32 H. CALCULATION OF V
Page 39 and 40:
SINCAP MDB - 34 NOTE: The “As Tes
Page 41 and 42:
SINCAP MDB - 36 Figure 9 - Moving D
Page 43 and 44:
SINCAP MDB - 38 (1) With the seat
Page 45 and 46:
SINCAP MDB - 40 (6) If the seat and
Page 47 and 48:
SINCAP MDB - 42 seat controls the f
Page 49 and 50:
SINCAP MDB - 44 combined cable bund
Page 51 and 52:
SINCAP MDB - 46 NR NB Nose to Rim -
Page 53 and 54:
SINCAP MDB - 48 A B C D E F G H I J
Page 55 and 56: SINCAP MDB - 50 C. MOVING DEFORMABL
Page 57 and 58: SINCAP MDB - 52 A. MDB Centerline t
Page 59 and 60: SINCAP MDB - 54 12.9 REMOVAL OF TES
Page 61 and 62: SINCAP MDB - 56 F. TEST REPORT No t
Page 63 and 64: SINCAP MDB - 58 M. The Contractor m
Page 65 and 66: SINCAP MDB - 60 13.4 NOTIFICATION O
Page 67 and 68: SINCAP MDB - 62 E. DRAFT TEST REPOR
Page 69 and 70: SINCAP MDB - 64 H. DELIVERABLE SCHE
Page 71 and 72: U.S. DEPARTMENT OF TRANSPORTATION T
Page 73 and 74: List of Figures TP-P572-U-00 Figure
Page 75 and 76: TP-P572-U-00 1. PURPOSE AND APPLICA
Page 77 and 78: TP-P572-U-00 8. CALIBRATION AND TES
Page 79 and 80: TP-P572-U-00 10. PRETEST REQUIREMEN
Page 81 and 82: TP-P572-U-00 10. PRETEST REQUIREMEN
Page 83 and 84: TP-P572-U-00 14. CHECK SHEETS CHECK
Page 85 and 86: TP-P572-U-00 CHECK SHEET NO. U1 (Co
Page 87 and 88: TP-P572-U-00 CHECK SHEET NO. U2 HEA
Page 93 and 94: TP-P572-U-00 __4 __5 CHECK SHEET NO
Page 97 and 98: TP-P572-U-00 CHECK SHEET NO. U4 SHO
Page 99 and 100: TP-P572-U-00 CHECK SHEET NO. U5 RIB
Page 105: TP-P572-U-00 CHECK SHEET NO. U7 ABD
Page 113 and 114: TP-P572-U-00
Page 115 and 116: TP-P572-V-00 Feb 2011 U.S. DEPARTME
Page 117 and 118: TP-P572-V-00 List of Figures Figure
Page 119 and 120: TP-P572-V-00 List of Tables Table V
Page 121 and 122: TP-P572-V-00 3. SECURITY….Continu
Page 123 and 124: TP-P572-V-00 9. PHOTOGRAPHIC DOCUME
Page 125 and 126: TP-P572-V-00 10. PRETEST REQUIREMEN
Page 127 and 128: TP-P572-V-00 14. CHECK SHEETS CHECK
Page 129 and 130: TP-P572-V-00 CHECK SHEET NO. V1 (Co
Page 131 and 132: TP-P572-V-00 CHECK SHEET NO. V2 HEA
Page 149 and 150: TP-P572-V-00 CHECK SHEET NO.V3 (Con
Page 157 and 158:
TP-P572-V-00 CHECK SHEET NO. V3 (Co
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
TP-P572-V-00 CHECK SHEET NO. V5 THO
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
TP-P572-V-00 PELVIS ACETABULUM IMPA
Page 183 and 184:
Page 185 and 186:
TP-P572-V-00 CHECK SHEET NO. V10 PE
Page 187 and 188:
TP-P572-V-00 CHECK SHEET NO. V10 (C
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
ATTACHMENT OF THORACIC AND ABDOMINA
Page 195 and 196:
P572-V-00
Page 197 and 198:
P572-V-00
Page 199 and 200:
SINCAP MDB - C2 ES-2re 50th Percent
Page 201 and 202:
SINCAP MDB - C4 SID-IIs 5th Percent
Page 203 and 204:
SINCAP MDB - C6 close to 20.0 degre
Page 205 and 206:
SINCAP MDB - D1 APPENDIX D ALUMINIU
Page 207 and 208:
SINCAP MDB - D3 FIGURE 1 2.3 Measur
Page 209 and 210:
SINCAP MDB - D5 2.6 Crush Strength
Page 211 and 212:
APPENDIX E. DELIVERABLE GUIDELINES
Page 213 and 214:
2 1. FINAL TEST REPORT Instructions
Page 215 and 216:
4 Block No. 1--REPORT NUMBER SINCAP
Page 217 and 218:
6 Block No. 17--KEY WORDS New Car A
Page 219 and 220:
8 Measurement Description Passenger
Page 221 and 222:
10 037 View of Disengaged Parking B
Page 223 and 224:
12 1.7 APPENDIX B - VEHICLE AND DUM
Page 225 and 226:
14 1.8 APPENDIX C - DUMMY PERFORMAN
Page 227 and 228:
16 Lower Spine Acceleration (G’s)
Page 229 and 230:
18 TABLE 4 - MDB Instrumentation MD
Page 231 and 232:
20 DATA SHEET NO. 1 (CONTINUED) GEN
Page 233 and 234:
22 DATA SHEET NO. 1 (CONTINUED) GEN
Page 235 and 236:
24 DATA SHEET NO. 2 (CONTINUED) SEA
Page 237 and 238:
26 DATA SHEET NO. 2 (CONTINUED) SEA
Page 239 and 240:
28 DATA SHEET NO. 4 DUMMY LATERAL C
Page 241 and 242:
30 DATA SHEET NO. 6 TEST VEHICLE AC
Page 243 and 244:
32 DATA SHEET NO. 8 POST-TEST OBSER
Page 245 and 246:
34 DATA SHEET NO. 9 MDB SUMMARY OF
Page 247 and 248:
36 DATA SHEET NO. 11 TEST VEHICLE E
Page 249 and 250:
38 DATA SHEET NO. 11 (CONTINUED) TE
Page 251 and 252:
40 DATA SHEET NO. 13 FMVSS NO. 301
Page 253 and 254:
42 3. FORMS Forms, like Data Sheets
Page 255 and 256:
44 1.1 Driver’s Seat 1.1A Seat Fo
Page 257 and 258:
1.2D Provide any other instructions
Page 259 and 260:
With the seat in the test seat trac
Page 261 and 262:
50 5. STEERING COLUMN AND WHEEL ADJ
Page 263 and 264:
52 9. DEACTIVATION OF SIDE AIRBAGS
Page 265 and 266:
___________________________________
Page 267:
56 Rev. 09/19/2012
Page 270 and 271:
FORM NO. 2 (CONTINUED) REPORT OF VE
Page 272 and 273:
FORM NO. 4 MONTHLY VEHICLE STATUS R
Page 274 and 275:
SINCAP MDB - F1 APPENDIX F Determin
Page 276 and 277:
SINCAP MDB - F3 (11) Again apply a
Page 278 and 279:
PROCEDURE FOR CHECKING AND RECORDIN
Page 280 and 281:
Figure 1 - Response of X Axis Accel
Page 282 and 283:
The channel outputs for the x-axis
Page 284 and 285:
Polarity Check Data Sheet For Y - A
show all

U.S. DEPARTMENT OF TRANSPORTATION - SaferCar.gov

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?