Isis Installation Guide - Big Ass Fans

30
® )
Isis ®
Electrical Installation (cont.)
Before wiring the controller, temporarily attach the mounting plate to the wall box and pull the wires through the center.
CAUTION: The fan must operate on a dedicated circuit with a dedicated neutral. Failure to install the fan on a dedicated
circuit will cause the fan to operate improperly.
(mounted locally to fan)
10 A 50 Hz
White
Green/
Yellow
Brown
Blue
AC Line/Neutral
(L2/N)
Earth/PE
AC Line (L1)
Wire Color Chart
50/60 Compatible
Power Supply Wire
Color
North America
100–120V System
North America
208–240V System
European Union, United
Kingdom
220–240V System
Australia*
240V System
AC Line (L1)
AC Line/Neutral
(L2/N)
Black White
Black, Red, or
Blue
Brown, Black, or
Grey
Brown or Red
Red, Blue, or
Black
Blue
Black or Light
Blue
Earth/PE
Green or Bare
Copper
Green or Bare
Copper
Green with Yellow
Tracer
Green with Yellow
Tracer
LED Off “OK”
One 1-Sec. Flash / 5-Sec. Off: Buss Under/Over voltage
Two 1-Sec Flashes / 5-Sec. Off: Motor Over-current
Three 1-Sec. Flashes / 5-Sec. Off: Communication/Motor Stall
Four 1-Sec. Flashes / 5-Sec. Off: Motor Over-temperature
Five 1-Sec. Flashes / 5-Sec. Off: Drive Over-temperature
* Note: If installing the fan in Australia, a licensed electrician must perform the electrical installation.
WWW.BIGASSFANS.COM ©2014 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED