Series CR Installation Manual PDF - Myers Power Products, Inc.

More documents

Recommendations

Info

This unit contains LETHAL VOLTAGES. All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY! There are NO USER SERVICEABLE PARTS inside this unit. IMPORTANT SAFEGUARDS When using electrical equipment, you should always follow basic safety precautions, including the following: 1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. 2. Do not install near gas or electric heaters or in other high-temperature locations. 3. Use caution when servicing batteries. Depending on battery type, batteries contain either acid or alkali and can cause burns to skin and eyes. If battery fluid is spilled on skin or in the eyes, flush with fresh water and contact a physician immediately. 4. Equipment should be mounted in locations where unauthorized personnel will not readily subject it to tampering. 5. The use of accessory equipment not recommended by Manufacturer may cause an unsafe condition and void the warranty. 6. Do not use this equipment for other its than intended use. 7. Qualified service personnel must perform all servicing of this equipment. SAVE THESE INSTRUCTIONS The installation and use of this product must comply with all national, federal, state, municipal, or local codes that apply. If you need help, please call Service. 1 114306E—Install/User <strong>Manual</strong>
C A U T I O N READ ENTIRE MANUAL AND REVIEW ALL DOCUMENTATION BEFORE ATTEMPTING SYSTEM INSTALLATION! FOR YOUR PROTECTION.... PLEASE COMPLETE AND RETURN WARRANTY REGISTRATION CARD IMMEDIATELY. 2 114306E—Install/User <strong>Manual</strong>
Page 1: INSTALLATION & USER’S GUIDE 3kW -
Page 5 and 6: SECTION 9 Options………………
Page 7 and 8: BATTERY STORAGE WARNING This shipme
Page 9 and 10: Record Keeping An on-site permanent
Page 11 and 12: SECTION 3 BEFORE INSTALLING THE SYS
Page 13 and 14: Receiving and Moving the Unit and t
Page 15 and 16: SECTION 4 AC INPUT & AC OUTPUT INST
Page 17 and 18: Table 4.2 Recommended Minimum Wire
Page 19 and 20: SECTION 5 INSTALLING BATTERIES AND
Page 21 and 22: Before Installing the Batteries Too
Page 23 and 24: Connecting the Cables Between Batte
Page 25 and 26: CAUTION Do not dispose of batteries
Page 27 and 28: BATTERY RETAINER BRACKET (TB1) INPU
Page 29 and 30: BRACKET BATTERY RETAINER DC FUSE (F
Page 31 and 32: SECTION 6 STARTUP AND SHUTDOWN PROC
Page 33 and 34: MAINTENANCE BYPASS PROCEDURE CAUTIO
Page 35 and 36: SECTION 8 FRONT PANEL DISPLAY The F
Page 37 and 38: Control Functions Control functions
Page 39 and 40: The Day of the Automatic Tests Tabl
Page 41 and 42: 3-PHASE SYSTEM: 1-POLE OUTPUT CIRCU
Page 43 and 44: REMOTE SUMMARY ALARM PANEL SCHEMATI
Page 45 and 46: SECTION 10 RS232 OPERATION 1.0 INTR
Page 47 and 48: 4.0 COMMANDS Meter Functions 4.1 Ge
Page 49 and 50: 4.7 Get Battery Current PC Interfac
Page 51 and 52: 5.8 Get Output Current Load Reducti
Page 53 and 54:
5.21 Get Alarm Log PC Interface: Sy
Page 55 and 56:
LOCATION OF THE RS232 PORT RS232 po
Page 57 and 58:
Fig. 10.5 56 114306E—Install/User
Page 59 and 60:
SECTION 11 SPECIFICATIONS Input Out
Page 61 and 62:
60 THE NUMBER IN THE CHART INDICATE
Page 63 and 64:
Heater Option Operation: The Heater
Page 65 and 66:
SECTION 15 WARRANTY RETURN MATERIAL
Page 67:
66 114306E—Install/User Manual
show all

Series CR Installation Manual PDF - Myers Power Products, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?