Series CR Installation Manual PDF - Myers Power Products, Inc.
Series CR Installation Manual PDF - Myers Power Products, Inc.
Series CR Installation Manual PDF - Myers Power Products, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION 13<br />
HEATER OPTION INSTALLATION AND OPERATION<br />
Heater Option <strong>Installation</strong>:<br />
CAUTION SHOULD BE USED WHEN INSTALLING THE BATTERIES TO PREVENT DAMAGE TO<br />
THE HEATING ELEMENTS LOCATED ON THE SHELF DIRECTLY ABOVE THE BATTERY.<br />
Remove the battery bracket located on each shelf before installing batteries. This bracket is used to<br />
secure the batteries once they are installed on each shelf.<br />
A separate utility feed is required for the heater option.<br />
The input power requirement is approximately 1,400 Watts. The power factor will be unity since the<br />
heater option consists of resistive heating elements.<br />
The following table is a matrix for most utility feed requirements. Your machine will be clearly labeled<br />
with its input voltage requirements – check your print package provided with your machine.<br />
Input Voltage<br />
Input Current<br />
120 VAC 12 Amps<br />
208 VAC 7 Amps<br />
240 VAC 6 Amps<br />
277 VAC 5 Amps<br />
480 VAC 3 Amps<br />
61<br />
114306E—Install/User <strong>Manual</strong>
Change language