ISOCAM Interactive Analysis User's Manual Version 5.0 - ISO - ESA

19.6. ADVANCED SLICING WITH X SLICER 223
x slicer name telemetry name SCD names a DSD names
CAM wheels positions
entrance wheel F1 W1 POS ENTWHL F1 BLOCK.HK1.POS1
CAL.EWHL
selection wheel F1 W2 POS SELWHL F1 BLOCK.HK1.POS2
CAL.SWHL
LW lens wheel F1 W3 POS PFOV F1 BLOCK.HK1.POS3
CAL.PFOV
LW filter wheel F1 W4 POS FLTRWHL F1 BLOCK.HK1.POS4
CAL.FCVF
SW lens wheel F1 W5 POS PFOV F1 BLOCK.HK1.POS5
CAL.PFOV
SW filter wheel F1 W6 POS FLTRWHL F1 BLOCK.HK1.POS6
CAL.FCVF
detector and its configuration
observation channel F2 IM ORIG CHANNEL F2 BLOCK.F2IMORIG
CAL.DEID
integration time F2 INT TIME TINT F2 BLOCK.F2INTTIM
CAL.TINT
detector gain F2 ADC GAIN GAIN F2 BLOCK.F2ADCGAI
CAL.GAIN
detector offset F2 ADC OFFS OFFSET F2 BLOCK.F2ADCOFF
CAL.OFFSET
electronic setup
on-board process F2 IM PROC OBP MODE F2 BLOCK.F2IMPROC
CAL.OBC
observation mode F2 AOT OPM MODE F2 BLOCK.F2AOTOPM
CAL.MODE
observation related variables
observation type F2 AOT OBS COMMANDER F2 BLOCK.F2AOTOBS
CAL.COMMANDER
A.O.T F2 AOT AOT AOCT F2 BLOCK.F2AOTAOT
beam-switching F2 OPER FLAG BEAM F2 BLOCK.F2BMSWFL
raster mode F RAST F RASTER F2 BLOCK.F RAST
M raster position M RAST M RASTER F2 BLOCK.M RAST
N raster position N RAST N RASTER F2 BLOCK.N RAST
parallel mode F2 PARALLEL TELEMETRY F2 BLOCK.F2PARALL
CAL.TELEMETRY
specific variables
On Target Flag F2 OTFLAG CUBE.HK.QLA FLAG b F2 BLOCK.F2OTFLAG
sequence number F2 AOT CNF STN F2 BLOCK.F2AOTCNF
a SCD names column sometimes contains two names. This is because you will find an explicit value of the
variable in the SCD top level, and an integer value in one of its substructures (usually the .CAL one).
b Note that only the OTF is allowed to vary in an SCD, because it is stored in the HK (house keeping)
substructure. All other variables have to be constant in an SCD. Moreover, OTF is only a part of the QLA flag.
Table 19.1: Slicing variables used in x slicer.