ISOCAM Interactive Analysis User's Manual Version 5.0 - ISO - ESA

More documents

Recommendations

Info

290 CHAPTER 21. USING SLICE WITHIN CIA Figure 21.2: The resulting maps for the Perturbed Single Flat-Field determination. Note that the map orientation has changed as SLICE always produces maps with North up and East left. Imprints of the individual raster pointings are still visible. Figure 21.3: The resulting maps for the first flat-field determination with the DivSky. Note that the “emission gradient”, produced by the long-term transient is much smoother now, and pointing imprints are mostly gone.
21.7. FREQUENTLY ASKED QUESTIONS AND PROBLEMS 291 Figure 21.1: The raster maps using a standard CIA procedure (see text for details). Left panel shows the LW3 data, while the right panel shows the LW2 data. Both data sets are affected by periodic patterns due to bad flat-field determination, as well as long term transients. Figure 21.6: The results of the long-term transient correction and variable flat-field determination. Variable flat-field was performed using the DivSky method, with parameter setup as indicated in Table 21.4. LW3 is on the left, and LW2 on the right. Compare with Fig. 21.1 to measure the improvement
Page 1 and 2:
ISOCAM Interactive Analysis User’
Page 3:
Michael Rupen (NRAO) Jaqui Sam Lone
Page 6 and 7:
vi CONTENTS 8 Polarization observat
Page 8 and 9:
viii CONTENTS 14.4.6 x3d as a calib
Page 10 and 11:
x CONTENTS 19.3 A beam-switch obser
Page 12 and 13:
xii CONTENTS B CIA command short-li
Page 14 and 15:
xiv CONTENTS
Page 16 and 17:
xvi LIST OF FIGURES 14.13The raster
Page 18 and 19:
xviii LIST OF FIGURES
Page 20 and 21:
xx LIST OF TABLES
Page 22 and 23:
2 CHAPTER 1. ABOUT THE CIA USER’S
Page 24 and 25:
4 CHAPTER 2. ABOUT CIA 2.2 System r
Page 26 and 27:
6 CHAPTER 2. ABOUT CIA Figure 2.2:
Page 28 and 29:
8 CHAPTER 2. ABOUT CIA In addition,
Page 30 and 31:
10 CHAPTER 2. ABOUT CIA 2.3.4 Custo
Page 32 and 33:
12 CHAPTER 2. ABOUT CIA LOG Log fil
Page 34 and 35:
14 CHAPTER 2. ABOUT CIA This will p
Page 36 and 37:
16 CHAPTER 2. ABOUT CIA % device, p
Page 38 and 39:
18 CHAPTER 2. ABOUT CIA
Page 41:
Introduction The Quick Start Guide
Page 44 and 45:
24 CHAPTER 3. RASTER OBSERVATION (C
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
32 CHAPTER 4. STARING OBSERVATION (
Page 54 and 55:
34 CHAPTER 4. STARING OBSERVATION (
Page 56 and 57:
36 CHAPTER 5. SOLAR SYSTEM OBJECT O
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
42 CHAPTER 6. BEAM-SWITCH OBSERVATI
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
48 CHAPTER 7. CVF OBSERVATION (CAM0
Page 70 and 71:
50 CHAPTER 7. CVF OBSERVATION (CAM0
Page 72 and 73:
52 CHAPTER 8. POLARIZATION OBSERVAT
Page 74 and 75:
Page 76 and 77:
Page 79:
Introduction The purpose of Part II
Page 82 and 83:
62 CHAPTER 9. THE DATA PRODUCTS AND
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
68 CHAPTER 10. FIRST LOOK AT THE DA
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
74 CHAPTER 11. INTRODUCTION TO CIA
Page 96 and 97:
76 CHAPTER 11. INTRODUCTION TO CIA
Page 98 and 99:
78 CHAPTER 12. DATA SLICING 3. At t
Page 100 and 101:
80 CHAPTER 12. DATA SLICING CIA> ns
Page 102 and 103:
82 CHAPTER 12. DATA SLICING equal t
Page 104 and 105:
84 CHAPTER 12. DATA SLICING OR CIA>
Page 106 and 107:
86 CHAPTER 12. DATA SLICING 70 16.0
Page 108 and 109:
88 CHAPTER 12. DATA SLICING • Sel
Page 110 and 111:
90 CHAPTER 12. DATA SLICING We sugg
Page 112 and 113:
92 CHAPTER 12. DATA SLICING title d
Page 114 and 115:
94 CHAPTER 12. DATA SLICING • Sel
Page 116 and 117:
96 CHAPTER 13. DATA CALIBRATION 13.
Page 118 and 119:
98 CHAPTER 13. DATA CALIBRATION •
Page 120 and 121:
100 CHAPTER 13. DATA CALIBRATION 13
Page 122 and 123:
Page 124 and 125:
104 CHAPTER 13. DATA CALIBRATION Fi
Page 126 and 127:
106 CHAPTER 13. DATA CALIBRATION au
Page 128 and 129:
108 CHAPTER 13. DATA CALIBRATION 2.
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
114 CHAPTER 14. IMAGE ANALYSIS AND
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 179 and 180:
Introduction The purpose of this pa
Page 181 and 182:
Chapter 15 CIA data structure high-
Page 183 and 184:
15.2. OBSERVATION DATA STRUCTURES 1
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
15.3. CALIBRATION DATA STRUCTURE (C
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
15.4. AUXILIARY CALIBRATION DATA 17
Page 199 and 200:
15.4. AUXILIARY CALIBRATION DATA 17
Page 201 and 202:
15.5. PREPARED DATA STRUCTURE (PDS)
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Chapter 16 Data structure manipulat
Page 209 and 210:
16.1. CIA DATA STRUCTURE INTERFACE
Page 211 and 212:
16.1. CIA DATA STRUCTURE INTERFACE
Page 213 and 214:
16.2. AN EXAMPLE OF SAD MANIPULATIO
Page 215 and 216:
16.4. MANIPULATING THE MASK 195 and
Page 217 and 218:
16.5. CDS DATA EXTRACTION 197 16.5
Page 219 and 220:
16.6. MANIPULATING CIA DATA STRUCTU
Page 221 and 222:
Chapter 17 Importing ISO data produ
Page 223 and 224:
17.2. IMPORTING FITS TO REGULAR IDL
Page 225 and 226:
Chapter 18 Export of CIA data struc
Page 227 and 228:
18.3. EXPORT FOR ARCHIVING 207 CIA>
Page 229:
Part IV Advanced Use of CIA 209
Page 232 and 233:
212
Page 234 and 235:
214 CHAPTER 19. ADVANCED SLICING 19
Page 236 and 237:
216 CHAPTER 19. ADVANCED SLICING Fi
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
226 CHAPTER 19. ADVANCED SLICING va
Page 248 and 249:
228 CHAPTER 19. ADVANCED SLICING Fo
Page 250 and 251:
230 CHAPTER 19. ADVANCED SLICING
Page 252 and 253:
232 CHAPTER 20. ADVANCED DATA CALIB
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261: 240 CHAPTER 20. ADVANCED DATA CALIB
Page 294 and 295: 274 CHAPTER 21. USING SLICE WITHIN
Page 314 and 315: 294 CHAPTER 22. SECOND ORDER CORREC
Page 316 and 317: 296 CHAPTER 22. SECOND ORDER CORREC
Page 318 and 319: 298 CHAPTER 23. X CIA REFERENCE GUI
Page 326 and 327: 306 APPENDIX A. GLOSSARY beam-switc
Page 328 and 329: 308 APPENDIX A. GLOSSARY FITS (data
Page 330 and 331: 310 APPENDIX A. GLOSSARY raster dat
Page 332 and 333: 312 APPENDIX A. GLOSSARY
Page 334 and 335: 314 APPENDIX B. CIA COMMAND SHORT-L
Page 340 and 341: 320 APPENDIX C. THE ISO CD-ROM C.2.
Page 342 and 343: 322 APPENDIX C. THE ISO CD-ROM Vari
Page 344 and 345: 324 APPENDIX D. GUIDELINES FOR WRIT
Page 346 and 347: 326 APPENDIX D. GUIDELINES FOR WRIT
Page 348 and 349: 328 APPENDIX E. ISOCAM ASTROMETRY:
Page 358 and 359: 338 APPENDIX F. WHAT IS NEW IN CIA
Page 360 and 361:
340 APPENDIX F. WHAT IS NEW IN CIA
Page 362 and 363:
342 APPENDIX F. WHAT IS NEW IN CIA
Page 364 and 365:
344 APPENDIX G. WARNING MESSAGES IN
Page 366 and 367:
346 APPENDIX H. PATCHED ASTROLIB AN
Page 368 and 369:
348 APPENDIX I. UPGRADING OLD CIA S
Page 370 and 371:
350 APPENDIX I. UPGRADING OLD CIA S
Page 372 and 373:
352 APPENDIX J. REPORTING PROBLEMS
Page 374 and 375:
354 APPENDIX K. TECHNICAL REPORTS S
Page 376 and 377:
356 BIBLIOGRAPHY Okumura K., 1998,
show all

ISOCAM Interactive Analysis User's Manual Version 5.0 - ISO - ESA

Create successful ePaper yourself

Delete template?

Save as template?