DCT5280 - at Uniden

[ 68 ]
Call Transfer Feature
From handset to handset or to the base
1) During a call, press intercom/hold on the handset.
2) Select a handset or the base to transfer the call to
within 10 seconds (refer to step 2 under “Intercom” Hold,to transfer
section). The call will automatically be placed on hold, Handset #2
and an intercom tone sounds. To cancel the transfer, Handset #3
BACK BACK OK
press the CANCEL soft key, talk/flash, speaker, or the
BACK soft key on the initiating handset.
3) On the receiving handset, to answer the page, press talk/flash, intercom/hold, or the
ANSWER soft key (or (talk) or intercom on the base). Or press any number key,
/tone/t, or #/s (when Any Key Answer is On), or pick up the handset from the
cradle (when AutoTalk is On). The intercom mode is activated, but the caller is still
on hold.
4) To speak to the caller, press talk/flash or speaker (or (talk) on the base) on the
receiving handset.
From the base to a handset
1) During a call, press intercom on the base. The call will automatically be placed on
hold, and an intercom tone sounds. All the handset(s) will be paged.
2) On the receiving handset, to answer the call, press talk/flash, intercom/hold, or the
ANSWER soft key. The intercom mode is activated, but the caller is still on hold.
Or press any number key, /tone/t, or #/s (when Any Key Answer is On), or pick
up the handset from the cradle (when AutoTalk is On).
3) To speak to the caller, press talk/flash, or speaker on the receiving handset.
Replacing the Base
EXPANDING YOUR PHONE
When you replace the base with a different base of the DCT series model (DCT5260,
DCT5280, or DCT5285 series), you need to clear the handset and base ID. To do this,
perform the “System Reset” menu options (“De-register the Handset” and “Replacing the
Base Setting” (see page 30), then register all the handsets you have (see page 65).