Theta Controller User Manual

2.5.6 Analyze
Analyze Screens
Options Screen
ANALYZE displays tool and controller diagnostic information, traces and I/O status.
User Manual
TOOL tab
This tab shows live status of the following
events. It is updated every millisecond. Use
this tab to perform diagnostics during
troubleshooting operations.
Transducer Health – The thickness of the
vertical line within the horizontal bar
indicates transducer health. The thicker the
line the less healthy. Once the line reaches
the tick mark, on either side of center, the
transducer zero shift can no longer be
compensated for and the transducer needs to
be replaced.
Transducer Torque – Provides a live
transducer torque value during the tightening
cycle.
Transducer Current – The transducer is
powered with a constant current value. This
current should be present and not varying.
See section 2.3 for limits.
Controller DC Bus voltage – The bus should
always be around 320 VDC.
Controller AC Supply Voltage / Frequency –
See section 1.3 for controller AC volts
specification.
Tool Temperature – Temperature is not
measured during tool operation. Interacts
with the Temperature Limit parameter. See
section 2.5.3/TOOL tab.
Tool Output Angle – number of circular
degrees of rotation on the output of the tool.
Resets at each start.
Tool Output Speed – Real time speed of the
output of the tool.
30