Carrier Compressors Service Guide

FOR HFCs:Carlyle has approved R-134a, R404A, R-507, and R-407C.The following POLYOL-ESTER (POE) are approvedoils for HFCs:Totaline ® (see Note 5).......P903-1001, 1701Castrol..(see Note 5) ............................ E68ICI Emkerarate .............................. RL68HCPI ............................................. CP-2916SCPI ............................................... Solest 68BP Marine Enersyn ....................... MP-S68All POE oils are very hygroscopic (will readily pick up andretain moisture from the air) and should be used completelyonce the container is opened. It is extremely difficult to resealthe oil container effectively enough to prevent moistureabsorption, which in turn forms damaging acids.NOTES:1. The use of any non-approved refrigerant may bedangerous and will void the warranty.2. Using the wrong type or weight of oil for therefrigerant selected will void the warranty.3. Follow the refrigerant and/or oil manufacturerinstructions when installing or retrofitting.4. Contact the Carlyle Compressor engineeringdepartment before using any refrigerant or oil notlisted in this guide as approved for use in a Carlylesemi-hermetic compressor.5. Castrol SW68 (Totaline ® P903-1001) is approved foruse in Carrier chiller applications as well as Carrierand Carlyle semi-hermetic compressors for airconditioning and medium temperature applications.Castrol SW68 (Totaline ® P903-1001) cannot beused in any new low temperature refrigerationapplications using Carlyle OEM semi-hermeticcompressors. Castrol E68 is approved for use inCarlyle OEM compressors for low, medium, andhigh temperature ranges.6. All HFC/POE applications require a crankcase heater.7. Moisture must be kept below 50 ppm for POE oils.8. In retrofit applications, a high flow oil pump isrequired.71