3DView manual milling - Emco Maier GmbH

EMCO WIN 3D-VIEW MILLINGBASIC SETTINGSPress the softkey "View".Input of the Basic Settings for SINUMERIK 810D/840Dwithout activated 4 th axisYou may define the followingsettings:Global resolution:You may select values between0.01 and 0.3. The higher theresolution, the exacter is thestructure of the 3D-picture.Line of vision:The "Line of vision" enables apresetting of the initial view onthe blank workpiece. However,the line of vision can always bechanged during simulation bymeans of the mouse.By pressing the softkey "standardview dir." the original view appearsagain.View mode:• Normal presentation• Wire frame complete • Wire framesectional view (related to WCS):The sectional view enables the observation of normallyhidden sequences.The position of the cut surface is defined by inputof coordinates.To display the sectional view, thesimulation has to be started again.• Transparent raw partsectional view17