Owner's Manual - La Toile des batteurs

Chapter 5. Trigger Settings [TRIGGER]Selecting the Pad Type[F1 (BANK)]To be sure the TD-12 accurately receives signals sent from thepads, select the trigger type (the type of pads being used) foreach trigger input.Trigger TypeA trigger type is a group of trigger settings with valuesoptimally adjusted for a particular pad. Indications such as“KD85,” “PD85,” or “VH11,” etc. in the above displaycorrespond to this. When you select a trigger type for aconnected pad, each of the parameters is set to the mostappropriate values for that pad, allowing you to play itwithout encountering problems with the settings. Only whenfactors unrelated to the selection of the proper trigger typeprevent you from getting good results in performance shouldyou fine-tune the individual parameters for the pad you areusing.Trigger BankTrigger Banks allow you to store the 15 trigger settings as asingle unit of information. The large number at the left edge ofthe above display is the Trigger Bank number. Move thecursor to this area to select the Trigger Bank.1. Press [TRIGGER] - [F1 (BANK)].[TRIGGER] lights, and the “TRIGGER BANK” screenappears.fig.05-TrigBank_70Trigger TypePD125PD120PD105PD100PD80RPD9PD8PD7PD6KD120KD80KD8KD7CY15RCY12RCCY14CCY8CY6CY12HVH12VH11PAD1PAD2RT7KRT5SRT3TUsed ModelPD-125PD-120PD-105PD-100PD-85, PD-80R, PD-80PD-9PD-8PD-7PD-6KD-120KD-85, KD-80KD-8KD-7CY-15RCY-12R/CCY-14CCY-8CY-6CY-12HVH-12VH-11When using a non-Roland padRT-7KRT-5SRT-3T* When you select the trigger type, the trigger parameters (exceptthe crosstalk cancel parameters) are automatically set to themost efficient values for each pad. Make settings for theparameter as needed.* When 3Way Trigger (p. 52) is set to ON, “RD CTRL” isdisplayed for the trigger type for TRIGGER INPUT 10 EDGE.It cannot be changed.2. Press [CURSOR (left)] to move the cursor to theTrigger Bank number.3. Use [+/-] or [VALUE] to select the Trigger Bank.4. Press [CURSOR (right)] to move the cursor to atrigger type.5. Strike the pad you wish to set.The cursor moves to the trigger type for the struck pad.You can also select by using [CURSOR] or [TRIGSELECT].6. Use [+/-] or [VALUE] to select the trigger type.Trigger Inputs and Pad/PlayingMethods corresponding chartTrigger InputDual TriggerMesh PadPositionalSensingRim ShotNuanceKICK – – –SNARE o o oTOM 1–3 o – oHI-HAT – – –CRASH 1, 2 – – –RIDE – o –EDGE – – –AUX 1, 2 o – o* Brush sweep and Cross Stick can be used only on SNARE.* Each playing method can be used with the instrumentscorresponding to it (p. 91).44