Owner's Manual - La Toile des batteurs

Chapter 5. Trigger Settings [TRIGGER]Eliminate Crosstalk BetweenPads [F4 (XTALK)]When two pads are mounted on the same stand, hitting onepad may trigger the sound from another pad unintentionally.(This is called crosstalk.) Eliminate this by adjusting XtalkCancel on the pad that is sounding inadvertently.In some cases, you can prevent crosstalk between twopads by increasing the distance between them.Crosstalk Example: If you hit the snare pad andthe tom 1 also soundsSet the snare and tom 1 to the same XTALK GROUP.Raise the “XTALK CANCEL” for the pad being used forthe tom 1. The tom 1 pad will be less prone to receivecrosstalk from other pads. With a setting “OFF,” crosstalkprevention will not work.* If the value is set too high, and two pads are playedsimultaneously, the one that is struck less forcefully maynot sound. Be careful and set this parameter to theminimum value required to prevent crosstalk.1. Press [TRIGGER] - [F1 (BANK)] - [F4 (XTALK)].2. Use [F1]–[F3] to select the parameter.3. Strike the pad you wish to set.The cursor will move to the trigger input number for thestruck pad.You can also select by using [CURSOR] or [TRIGSELECT].4. Use [+/-] or [VALUE] to adjust the setting.5. When you’re finished, press [EXIT] to return tothe “DRUM KIT” screen.[F1 (XTALK)]: XTALK CANCELfig.05-Xtalk1_70Chapter 5[TRIGGER][F2 (MOUNT)]: MOUNT TYPESelect the pad mount type here.SEPARATE: Using a separate stand or no standPAD: Using a pad mountCYMBAL: Using a cymbal mountfig.05-Xtalk2_70[F3 (GROUP)]: XTALK GROUPCrosstalk Cancel affects the pads set to the same number.fig.05-Xtalk3_7049