Owner's Manual - La Toile des batteurs

Chapter 9. Settings for the Entire TD-12 [SETUP]Function AUX1 AUX2Head Rim Head RimUSERSelect from the table below.OFFKIT# INCKIT# DECCHAIN# INCCHAIN# DECPTN# INCPTN# DECXSTICK SW• If you don’t want sound from the pad used as a padswitch, press [MIXER] - [F1 (VOLUME)], and set thevolume level for AUX2 and/or AUX1 to “0” (p. 39). Orpress [INST] and select “561 Off” for AUX2 and/or AUX1(p. 33).• To prevent triggering playback of patterns when the padis hit, switch off the Pad Pattern setting (p. 37).• When using pad switches to switch kits in a Drum KitChain (p. 80), FUNCTION should be set to “KIT SELECT1” or “KIT SELECT 2,” and you need to press the[CHAIN], so its indicator is lit. (The Drum Kit Chainsettings need to be made beforehand.)PREVIEW Button Velocity[F2 (PREVIEW)]You can check the sound of the instrument assigned to theselected input by pressing [PREVIEW]. The proceduredescribed here sets the velocity (volume) used in playing theinstrument when [PREVIEW] is pressed.1. Press [SETUP].Turns off Pad Switch.Calls up the next kit.Calls up the previous kit.Calls up the next drum kit chain.Calls up the previous drum kit chain.Calls up the next pattern.Calls up the previous pattern.Switches the cross-stick sound on andoff (p. 32).[SETUP] lights, and the “SETUP” screen appears.• You can press [PREVIEW] to preview sounds at thevelocity corresponding to the cursor position.• By holding down [KIT] when you press [PREVIEW], youcan shift through three separate velocity levels set here asyou check the sound (p. 25).Adjusting the Display Contrast[F3 (LCD)]The display contrast is strongly influenced by the location ofthe TD-12 and the lighting of the room it’s in. Adjust thisparameter when needed.1. Press [SETUP].[SETUP] lights, and the “SETUP” screen appears.2. Press [F3 (CONTROL)] - [F3 (LCD)].The “LCD CONTRAST” screen appears.fig.09-Contrast_703. Use [+/-] or [VALUE] to adjust.* You can also adjust it by holding [KIT] and turning [VALUE].Checking the TD-12’s InternalProgram Version [F5 (VERSION)]1. Press [SETUP].[SETUP] lights, and the “SETUP” screen appears.2. Press [F3 (CONTROL)] - [F5 (VERSION)].The “VERSION INFORMATION” screen appears.fig.09-Version_702. Press [F3 (CONTROL)] - [F2 (PREVIEW)].The “PREVIEW” screen appears.fig.09-Preview_70Chapter 9[SETUP]3. Press [CURSOR (up/down)] to select thevelocity you wish to set.4. Use [+/-] or [VALUE] to make settings.77