Owner's Manual - La Toile des batteurs

Chapter 5. Trigger Settings [TRIGGER]Connecting the VH-11 and Adjustingthe TD-127. Press [F3 (HI-HAT)].The “TRIGGER HI-HAT” screen appears.fig.05-VH11-Offset2Connecting the Hi-Hatfig.VH-Connect.e8. Confirm the TD-12’s settings.CONTROLOUT jackto theTD-12’sHH CTRL jackTRIGGEROUT jackto theTD-12’sTRIGGER INPUTHI-HAT jackParameterValueHi-Hat TypeVH11/FDCC Max 90CC Resolution NORMAL9. While reading the meter displayed on the rightside of the TD-12’s screen, adjust the offsetwith the VH-11’s VH offset adjustment screw.Adjust the offset so that a blackmeter.fig.05-VH11-Offset3appears in theMaking the Hi-Hat Settings1. Confirm that the VH-11 and TD-12 areconnected properly.2. After making the hi-hat settings, release yourfoot from the pedal, and while keeping your footoff the pedal, turn on the power to the TD-12.* The offset cannot be adjusted correctly if the hi-hat is makingcontact with the motion sensor unit when the power is turned on.fig.Offset.eVH OffsetAdjustmentScrewOPENCLOSEChapter 5[TRIGGER]3. Loosen the clutch screw and let the hi-hat restnaturally on the motion sensor unit.4. Press [TRIGGER] - [F1 (BANK)].[TRIGGER] lights, and the “TRIGGER BANK” screenappears.5. Press [CURSOR] to move the cursor to thetrigger type for TRIGGER INPUT 6.6. Use [+/-] or [VALUE] to select “VH11.”fig.05-VH11-Offset1VH Offset Adjustment PointsIf the closed hi-hat sound is difficult to attain, rotate theVH offset adjustment screw towards “CLOSE.”If the open hi-hat sound is difficult to attain, rotate thescrew towards “OPEN.”If the sound cuts off when you strike the hi-hatforcefully, rotate the VH Offset adjustment screwtowards “OPEN.”10. If you need, make further adjustments to otherparameters (p. 46).47