AT COMMAND SET HILO/HILONC MODULES - Libelium

page 108/3395.15. +CPIN Command: Enter pinAT+CPIN Enter pinTest commandSyntaxAT+CPIN=?ResponseOKRead commandSyntaxAT+CPIN?Write commandSyntaxAT+CPIN=[,]Reference[27.007] § 8.3Response+CPIN: OKResponseOKParameters:values reserved by this TS:READY ME is not pending for any passwordSIM PIN ME is waiting SIM PIN to be givenSIM PUKSIM PIN2SIM PUK2ME is waiting SIM PUK to be given. Also, a second pin,, is used to replace the old pin in the SIM andshould thus be suppliedME is waiting SIM PIN2 to be given (this isrecommended to be returned only when the last executedcommand resulted in PIN2 authentication failure (i.e. +CMEERROR: 17); if PIN2 is not entered right after the failure, it isrecommended that ME does not block its operation)ME is waiting SIM PUK2 to be given (this isrecommended to be returned only when the last executedcommand resulted in PUK2 authentication failure (i.e. +CMEERROR: 18); if PUK2 and new PIN2 are not entered rightafter the failure, it is recommended that ME does not blockits operation). Also, a second pin, , is used toreplace the old pin in the SIM and should thus be suppliedPH-NET PIN ME is waiting personalization password to be given, : string type value (8 characters max.)Notes• Parameter can only be used if SIM is PIN blocked. must be PUK.Otherwise, the command is rejected• If the SIM card is extracted, AT+CPIN? will answer with a maximum of 30 secondsNote d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009