AT COMMAND SET HILO/HILONC MODULES - Libelium

page 81/3394.3. D Command: Mobile originated call to dial a numberATD Mobile originated Call to dial a numberTest commandSyntaxATD=?Response1 2 3 4 5 6 7 8 9 0 * # + A B C D P T W , @ !OKRead commandSyntaxATD?Response1 2 3 4 5 6 7 8 9 0 * # + A B C D P T W , @ !OKExecute commandSyntaxATD[][;]Response:NO DIALTONEBUSYNO CARRIERNO ANSWERCONNECT[]OKThe connection cannot be establishedData connection successfully connectedIf successfully connected and voice callParameters:: String of dialing digits and optionally V.25ter modifiers (dialing digits): 0-9, *, #, +, A, B, C (maximum length: 20 digits): Only required to set up voice calls. TA remains in command mode.ReferenceV.25TerNotes• The command may be aborted generally when receiving an ATH command duringexecution• Same behavior for ATDP, ATDR, ATDT, ATPD, ATRD, ATTD• OK answer may arrive after just after the ATD command or after the call is actuallyactive (see AT+COLP, chapter 6.11)Note d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009