AT COMMAND SET HILO/HILONC MODULES - Libelium

page 115/3395.22. +KRIC Command: Ring indicator controlAT+KRIC Ring indicator controlTest commandSyntaxAT+KRIC=?Response+KRIC: (list of supported s),(list of supported s)OKRead commandSyntaxAT+KRIC?Response+KRIC: ,< shape >OKWrite commandSyntaxAT+KRIC=[,]ResponseOKParameters: Use of RI signal0x00: RI not used.0x01: RI activated on incoming calls (+CRING, RING)0x02: RI activated on SMS (+CMT, +CMTI)0x04: RI activated on SMS-CB (+CBM, +CBMI)0x08: RI activated on USSD (+CUSD)0x10: RI activated on network state (+CIEV): signal shape – available only for incoming calls0: Repeat pulsesThe total length of the pulse is equivalent to the transfer of the RING orCRING notification1: Always activeThe signal is set to active during the whole incoming call notificationReferenceSAGEMCOMMUNICATIONSProprietaryNotes• For a SMS and other unsolicited messages, only one pulse is set.• If the 0710 is woken up by an incoming call only one pulse is set, even if shape=0 isused.• The width of the pulse is 1s.• Setup command only to send once to define the RI behavior.• Do not use the command while an incoming call, SMS, SMSCB, USSD…Note d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009