AT COMMAND SET HILO/HILONC MODULES - Libelium

page 78/3393.27. *PSCSSC Command: Call Successful setup controlAT*PSCSSC Call Successful setup controlRead commandSyntaxAT*PSCSSC?Write commandSyntaxAT*PSCSSC=Response*PSCSSC: OKResponseOKParameter :0 : default mode, OK is retuned after call is connected to the called party(successful call setup).1 : OK is returned when call setup is started .The user is not informed ofcall successful setup. If the calls fails, NO_ANSWER or NO_CARRIER will be sentafter the OK.ReferenceSAGEMCOMMUNICATIONSProprietaryNotes• This command controls the emission of the result code for MO speech successfulsetup..• If “Connected line identification presentation” supplementary service is activated(refer to +COLP), result code for ATD command will be sent to TE when call isconnected to the called party (successful call setup).• If “Connected line identification presentation” supplementary service is NOTactivated (refer to +COLP), result code for ATD can be sent as soon as call setupis started or after call is connected to the called party (after (successful call setup).• Set command allows selection of for MO speech call result code.• If user set =1 when +COLP is also activated, ERROR will be returned.Mode will remains to 0.• Read command returns current .Note d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009