AT COMMAND SET HILO/HILONC MODULES - Libelium

page 80/3394.2. H Command: Disconnect existing connectionATH Disconnect existing connectionExecute commandSyntaxATH[]Response:OKParameters:: Type of call affected by ATH request. Voice call disconnection is alsodependant of +CVHU settings.0: Same behavior as without parameter. Disconnect ALL calls on thechannel he command is requested All active or waiting calls, CS datacalls, GPRS call of the channel will be disconnected.1: Disconnect all calls on ALL connected channels. All active or waitingcalls, CSD calls, GPRS call will be disconnected (clean up of all calls ofthe ME).2: Disconnect all connected CS data call only on the channel thecommand is requested (Speech calls (active or waiting) or GPRS callsare not disconnected).3: Disconnect all connected GPRS calls only on the channel thecommand is requested (Speech calls (active or waiting) or CS datacalls are not disconnected).4: Disconnect all CS calls (either speech or data) but does not disconnectwaiting call (either Speech or data) on the channel the command isrequested.5: Disconnect waiting call (either speech or data) but does not disconnectother active calls (Either CS speech, CS data or GPRS) on the channelthe command is requested. (rejection of incoming call)ReferenceV.25TerNotes• On this command, all calls in progress are ended• See also AT+CHLDNote d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009