AT COMMAND SET HILO/HILONC MODULES - Libelium

page 138/339ReferenceNotes• The module internal temperature reaches either operating or extreme levels;the unsolicited message is in the format:+KTEMPMEAS: ,where: - threshold level-2 - extreme temperature lower bound (see below Note)-1 - operating temperature lower bound (see below Note)0 - normal temperature1 - operating temperature upper bound (see below Note)2 - extreme temperature upper bound (see below Note) - actual temperature expressed in Celsius degrees.• Typical temperature bounds are represented as following;Extreme Temperature Lower Bound -40°COperating Temperature Lower Bound -20°COperating Tem perature Upper Bound +55°CExtreme Temperature Upper Bound +85°C• Due to temperature measurement uncertainty there is a tolerance of +/-2°C• Be aware that if GPIO 6, 7, 8 are used no debug traces can be used.• For +KSIMDET, +KSYNC, +KTEMPMON, +KGSMAD, when they were enabled,they all will use GPIO as their output/ input pin; +CME ERROR: 3 will be issued toavoid conflict, when any two commands try to share the same GPIO pin.• Do not use +KGPIOCFG or +KGPIO to control the GPIO pin, when this pin hasbeen used by +KSIMDET, +KSYNC, +KTEMPMON, +KGSMAD. Thesecommands can manage the GPIO pin by themselves.Note d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009