AT COMMAND SET HILO/HILONC MODULES - Libelium

page 145/3395.46. +KCELLSCAN Command: Cell scan functionalityAT+KCELLSCAN Network Scan functionalityTest commandSyntaxAT+KCELLSCAN=?Response+KCELLSCAN: (list of supported s), (list of supported s), (list ofsupported s), (list of supported s)OKRead commandSyntaxAT+KCELLSCAN?Response+KCELLSCAN: OKWrite commandSyntaxAT+KCELLSCAN=[,[,[,[,]]]]]ResponseOKwhen =2 and command successful+KCELLSCAN: ,,,,,,OKParameters: 0 deactivate cell scan1 activate cell scan2 request cell information: PLMN identifiers (3 bytes), made of MCC (Mobile Country Code), andMNC (Mobile Network Code). If not specify, search on entire band.: 0 No Unsolicited Result Code sent at the end of the scan1 Unsolicited Result Code sent at the end of the scan [1..120] timeout in s for sending Unsolicited Result Code(default: 60): 0 reserved for future purposes: Absolute Radio Frequency Channel Number: Base Station Identify Code: Location Area: Cell ID, 4 hexadecimal digits, e.g. ABCD.: Received signal level of the BCCH carrier, decimal value from 0 to 63.The indicated value is an offset which should be added to –110 dBm toget a value in dBm. See the formula specified in TS 05.08 RadioSubsystem Link Control.: Routing AreaUnsolicited Notification+KCELLSCAN: ,,,,,,Note d’étude / Technical document :URD1– OTL 5635.1– 008 / 70248 Edition 07AT Command Set for SAGEM HiLo/HiLoNC Modules24/06/2009