ManageEngine ADManager Plus :: Help Documentation

ManageEngine ADManager Plus :: Help Documentation
2. While creating an user, I get the following error "Error in setting the
Password. There is a naming violation - Error Code : 80072037"
One possible reason for this error could be creation of a user in an invalid container.
3. While creating/modifying an user, I get the following error "The server is
unwilling to process the request - Error Code : 80072035"
The possible reasons for this error could be:
1. While setting the password, if the password complexity requirement as defined in
the password policy is not met. For example, the password policy might state that
the password should be alphanumeric and if the password specified do not
comply this, you might get this error.
2. When you try to remove a non-existing user object from a group.
3. When your try to remove a user from his/her primary group.
4. When modifying the SAM Account Name format for multiple users and when more
than one user happen to have the same SAM Account Name.
4. While creating an user, I get the following error " Error In Setting Terminal
service Properties. The specified user does not exist - Error Code : 525"
One possible reason could be that the user or the system account as which the product
is run do not have an account in the target domain. Terminal Service properties can only
be set if the user account or the system account (applies when ADManager Plus is run as
a service) that runs ADManager Plus has an account on the target domain.
5. I have updated the exchange attributes using ADManager Plus, but the
properties are not updated in the Exchange Server yet.
ADManager Plus modifies the exchange properties in the Active Directory. The changes
may not immediately reflect in the Exchange Server. It will get updated after some time.
6. I am not able to set the Terminal Services properties for the user?
One possible reason could be that the user or the system as which the product is run do
not have an account in that domain.
Refer to here for starting ADManager Plus in User or System account.
7. I am getting an error as "The attribute syntax specified to the directory
service is invalid - Error Code : 8007200b"?
This could happen in the following scenarios:
1. When modifying multiple users, if you try to remove (or making the value as
blank) an non-existing attribute
2. When adding a user, if you specify a blank value for an attribute.
8. When I create/modify an user, I get the following error " A device attached
to the system is not functioning - Error Code : 8007001f "
The possible reasons for this error could be:
ZOHO Corp. 176