INSTALLATION GUIDE - Big Ass Fans

More documents

Recommendations

Info

16PIVOT5. Attach pivot jointIf the fan will not be pivoted, it is not necessary to install the pivotjoint. Skip this step and proceed to Step 6b.CAUTION: Install the bolts exactly as shown. Do not pivot the fanuntil it has been completely assembled.Balance/Pivot Hardware:a. b. c. abbcDo not fully tighten bolts until fan is completely assembled!6a. Attach lower yoke (to pivot joint)CAUTION: When the fan is pivoted, the motor should never be lower than the gearbox. This will protect the motor in casethe gearbox leaks. Consider how the fan will eventually be pivoted and position the motor accordingly.CAUTION: Install the bolts exactly as shown. Do not pivot the fan until it has been completely assembled.CAUTION: The motor frame is heavy. Use care when raising it.bolts.Proceed to Step 7.abLower Yoke Hardware:a. b. c. bcDo not fully tighten bolts until fan is completely assembled!WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN ALL RIGHTS RESERVED
PIVOT176b. Attach lower yoke (to extension tube)CAUTION: The motor frame is heavy. Use care when raising it.The lower yoke can only be attached to the extension tubethrough the topmost and bottommost holes on the lower yoke.Lower Yoke Hardware:a. b. c. cbba7. Attach center capSnap the center cap onto the bottom of the main fan unit.WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN ALL RIGHTS RESERVED
Page 2: PIVOTInstallation ChecklistDid a st
Page 7: PIVOTContentsIntroduction Safety In
Page 12 and 13: 4Parts included (cont.)PIVOTCageSec
Page 14 and 15: 6Preparing the work sitePIVOTMechan
Page 16 and 17: PIVOT8 Mounting Structure: I-BeamBi
Page 18 and 19: PIVOT10 2. Pre-drill angle ironsØ
Page 20 and 21: 12PIVOT4b. Fasten double angle iron
Page 22 and 23: PIVOT14 Hanging the Fan1. Attach ba
Page 26: PIVOT18 Installing Airfoils1. Attac
Page 29 and 30: PIVOTPivoting the Fan211. Adjust pi
Page 31 and 32: PIVOT234. Install remaining guy wir
Page 33 and 34: Power requirements for fan controll
Page 35 and 36: Power wiring guidelines (cont.)PIVO
Page 37 and 38: PIVOTWiring: Early Suppression Fast
Page 39 and 40: PIVOTWiring: 200-250V three-phase f
Page 41 and 42: Daisy ChainingPIVOT33WARNING: Wait
Page 43 and 44: Operating the fan controllerPIVOT35
Page 45: Annual Maintenance ChecklistFan Mod
Page 48 and 49: PIVOT40 Warranty Return Instruction
Page 51 and 52: Warranty Claim Formassfans.comName
Page 53 and 54: Check-In Procedure(for Big Ass assf
Page 55 and 56: Close-Out Procedure(for Big Ass ass
Page 60: 1001010801Rev. H2348 Innovation Dri

INSTALLATION GUIDE - Big Ass Fans

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?