INSTALLATION GUIDE - Big Ass Fans

Operating the fan controllerPIVOT35WARNING: The following startup procedures apply to standard model controllers. Procedures may vary depending oninstallation options and system automation. The installer should verify proper wiring, terminations, and proper voltageStarting and stopping the fanAUTOFWDRUNfunctions. To start the fan,To stopthe fan, press the red STOP button.REVMR FRUNSTOPDrive Idle/Stopped ScreenSTOPAdjusting fan speedTo adjust fan speed,speed until the button is released.AUTOMFWDREVR FRUNSTOPR FthenMReversing direction of fan rotationindicating the pending change.Fan Speed Percentage Display(73.5% running FWD)AUTOFWDREVRUNMRFSTOPTypical Fault Message Display(Incoming Line Over-Voltage shown)months. If the fan is not rotating in this direction, press the Direction button, and then press the Memory/Enter button. During theWWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN ALL RIGHTS RESERVED