Operator's Manual

LNC-M520iCNC OperationThe Below Table Describes Each Soft Panel Function Selection Switches:Function Switches ON OFFHand Wheel DryRunHand wheel can modify theprogram coordinate, but theservo axis will not moveHand wheel can modify theprogram coordinate and let theservo axis moves according to it.actually.Automatic executing power Auto-OFF.Auto-OFF disconnecting and exit motionsafter finish program executing.Optional SkipProgram begins with ”/”symbol will be skipped and notSingle block that begins with ”/”symbol will be executed normally.be executed.Optional StopThe program will stop whenthe program executes up toM01. If want to continueController will ignore M01 andexecutethe next single block directly.executing, users need topress ”CYCLE START”.While executing the program,the servo feed is according toThe designated speed of the servofeed program.Dry Runthe dry run speed parameter,not according to theassigned speed of theprogram.MST IgnoreIgnore M, S, T codes Consider M, S, T codescommandingcommandingThe controller will continueexecuting program while theThe moving command of the servoaxis will be outputted with theMachine Lockprogram is executing. But, the program while the program ismoving command of the servo executing.axis will NOT be outputted. Soactually, the servo axis isLNC Technology Co., Ltd. 101