Operator's Manual

LNC-M520iCNC Operation• 【EDIT CYCL】This function key is effective when the editing cursor is stop at 【INS CYCL】 commandblock or there is G Code in that 【INS CYCL】 block. To press this key will enter into“Insert-3” page. If there is no assigned M Parameter (working style) value after G code,“Insert-2” page will occur.• 【LDEL】(Row Delete)Able to delete a row of program codes at the cursor position.• 【MARK】Pressing【MARK】at the right side of the screen to move the cursor to the wanted markingrow’s starting/ending point. Moving the cursor to the starting/ending position of the wantedmarking row and pressing the【MARK】function key again to mark the designated markingrows. Please refer to the below figure.Figure 2.5-8 Marking Function Page38 LNC Technology Co., Ltd.