Operator's Manual

LNC-M520iOP Panel Operation3.2 Power Switch (ON/OFF)When users press ON button on power switch, the CNC controller’s power will be enable.On the other hand, when users press OFF button, must wait for a while until the servo iscompletely release electricity and then the CNC controller’s power will be disable.3.3 EMG-STOP KeyEMG STOPUsing this butting under the condition of danger or emergency and all motions will stop. Tocancel is to turn the button by following the arrow direction. When the button is jump upautomatically, the emergency stop is released. When the button is pressed, the system isin “Not Ready” condition (condition column will occur “Not Ready”). In order to reachcompleted safety, the feed driver power in the power cabinet will be disconnected. Beforereleasing emergency stop, please ensure whether or not the broken source is excluded.Please executing home return procedure after the emergency stop is released in order toensure the accuracy of the coordinate position.114 LNC Technology Co., Ltd.