Operator's Manual

LNC-M520iCNC Operation2.6 OFFSETPressing to enter into the offset function screens such as 【TL. OFF】,【MACRO】, and 【WORK】. Users are able to modify these settings under MDI mode ormachine ready mode.2.6.1 TOOL OFFSETPressing 【TL. OFF】to enter into the below screen (Figure 2.6-1) and to key-in datamanually under MDI mode.1. 30 sets of setting for Tool Offset. To switch the setting screen by using and keys.2. To move highlighter on the wanted setting numbers. To key-in the setting value in thedata enter rows and then to press key to write into the controller.3. Absolute coordinate will change with tool offset everytime the part grogram uses onetool offset number. The value is:Figure 2.6-1 TL. OFF Screen56 LNC Technology Co., Ltd.