Operator's Manual

LNC-M520iCNC Operation• CUT PARAMThis page is mainly to set the cutting parameter of a single production procedure in aproject. Pressing the return button to switch back to the figure transmitting mainfunction page after complete setting. Please refer below as the related screen:Figure 2.8-10 CUT PARAM PageUsers only need to use the figure shape reminding at the upper right side and then tokey-in the related information in order complete setting. When the setting column isthe diameter (Parameter # T), a function key as “T Set” will occur. The function buttonis to key-in the 2 times of the radius compensation value of the corresponding toolnumber at the OFFSET page into this column according to the setting tool number atthe main function page.78 LNC Technology Co., Ltd.